User Manual

minnkotamotors.com
3. Remove control box cover
screws and cover using Phillips
screwdriver. (Figure 9)
4. If the trolling motor has
AutoPilot it must be removed
as follows:
a. Disconnect all six
AutoPilot connectors from
AutoPilot controller, using
a needle-nose pliers and a
utility knife to remove any
heat shrink insulation that
may exist. (Figure 10)
b. Remove the AutoPilot
controller from the head
of the trolling motor.
(Figure 11)
FIGURE 9
FIGURE 10
FIGURE 11
14
minnk
ota
m
oto
r
s.com