Installation Instructions

4
HANG DOORS
• Mount rear door first by tilting
door back and resting hangers
on rear rail.
• Repeat for front door on front rail.
3
• Place carriers on back of each door at the distance shown from the outside
edge for your model.
• Using carriers as a template, drill 3/32" holes and secure with
(#8 x 3/4") screws. (E)
• Drill 7/8" diameter hole approximately 1/4" deep on outside edge
of each door as shown to mount pulls.
MOUNT DOOR HARDWARE
SLIDING DOOR HARDWARE - BY PASS
Assembly
Instructions
#310387_A (1213)
5
ADJUST AND FINISH
• Adjust door to square with sides of door opening for your model as shown.
• To lock in place, drill 3/32" hole and secure with (#8 x 3/4") screw. (E)
• Install door guide where doors overlap.
• Install door stop to back side of front
door to keep rear door pull accessible
when front door is opened.
OR
36"
(91,4 cm)
2" (5,1 cm)
Right Edge
Bord droit
Borde derecho
Left Edge
Bord gauche
Borde izquierdo
1-3/16"
(3 cm)
1/2"
(1,3 cm)
1/2"
(1,3 cm)
Both sides
Deux côtés
Ambos lados