Installation Guide

IMPORTANT: DO NOT RETURN TO STORE!
For missing or damaged parts, technical or assembly questions, please call John Louis Customer
Service at 1-800-480-6985
SHELF COVER ASSEMBLY INSTRUCTIONS
Quantity: 1
Shelf Panel
Panel Del Estante
Panneau de Tablette
STEP 1 - SIZING SHELF COVER
1. Measure shelf depth
2. Determine shelf panel depth
NOTE: If shelf length is less than panel length, measure and cut panel to
required length with saw.
Quantity: 1 2 1/2in. Shelf Rail / 6.35cm. Plataforma Carril / 63.5mm. Rail d’étagère
Quantity: 1 2”in. Shelf Rail / 5.08cm. Plataforma Carril / 50.8mm. Rail d’étagère
Quantity: 1 1in. Shelf Rail / 2.54cm. Plataforma Carril / 25.4mm. Rail d’étagère
STEP 2 - ATTACHING SHELF RAIL
- 2in. Or 2.5in. Prole
3. Cut away excess panel depth.
4. Place onto shelf.
2. Place a shelf clip on the back of the shelf rail.
3. Use pilot hole that lines clip between shelf wires & repeat at each position.
4. WITH SPACER (Used when shelf has shelf ends) - Place spacers then
clips at locations & secure with 1in. screws.
5. WITHOUT SPACER - Secure shelf clips to shelf rails using 1/2in. screws.
6. Insert the shelf panel into the groove on the back of the shelf rail.
7. Place clips over wire shelf end.
8. Push clips closed tightly over wire shelf.
12in.
16in.
20in.
NOTE: If shelf length is less than rail length, measure and cut rail to
required length with saw.
1. Select desired shelf rail. Typically determined by amount of front face on
wire shelf.
Quantity: 4
1/2in. Screw
1.27 cm.Tornillo
12.7 mm. Visser
Quantity: 4
1/2in. Screw
1.27 cm.Tornillo
12.7 mm. Visser
Quantity: 4
Clip
Recortar
Fixez
Quantity: 4
Spacer
Espaciador
Entretoise
1. Select 1in. shelf rail & remove tape cover.
2. Secure prole to panel (tape adheres to nish side)
NOTE: If shelf length is less than rail length, measure and cut rail to
required length with saw.
STEP 2 - ATTACHING SHELF RAIL
- 1in. Prole
Quantity: 1
Panel Tape
Cinta Del Estante
Ruban de Tablette