Jinko Solar 410w Eagle G2 Silver Installation

9
JINKOSOLAR.US
Middle modules installationFringe modules installation
Figure 3: PV module installed at the side with Clamp fitting method
2.3.2 Mounting with Clamps
The module clamps should not come into contact with the front glass and must not
deform the frame. Be sure to avoid shading effects from the module clamps. The module
frame is not to be modified under any circumstances. When choosing this type of clamp-
mounting method, please be sure to use at least four clamps on each module. Two clamps
should be attached on each long side of the module. The applied torque value should be
high enough to mount the modules steadily. (Please consult with the clamp or racking
supplier for the specific torque value). Please find detailed mounting information in the
below illustration. The mounting zone is greater than J and less than K. Figure 3 shows
how a clamp should be mounted to the module frame.
When installing modules using clamps on the long side of the frame, the applicable
product types and installation locations are shown in Figure 4 and Table 4. When installing
modules using clamps on the short side of the frame, the applicable product types and
installation locations are shown in Figure 5 and Table 5.
When installing modules using clamps on the long side & short side of the frame, the
applicable product types and installation locations are shown in Figure 6 and Table 6.