Product Manual

10
Figure 6-7: abrasive trimming – JWDS-1836 ONLY
1. Press fastener lever (Figure 6-8) on outboard
(left) end of drum, and insert tapered end of
abrasive through slit in fastener, as shown.
Insert approximately 3-inches of abrasive strip
into fastener. Align tapered edge of abrasive
strip with left edge of drum.
Figure 6-8
2. Release fastener lever to secure end of strip.
3. Begin wrapping abrasive around drum. The
tapered edge of strip end should follow as close
as possible to edge of drum.
4. Continue to wrap abrasive in spiral fashion by
rotating drum with one hand and guiding strip
with the other. See Figure 6-9.
Successive windings of strip must not have any
overlap. They should be flush with previous
windings or with a slight gap between.
Figure 6-9
5. Press inboard take-up lever (Figure 6-10) and
insert trailing end of strip as far as it will go. If
necessary, trim tapered end of abrasive strip.
6. Release inboard take-up lever to secure strip.
All abrasive strips will stretch over time as they are
used, and may stretch enough to allow the take-up
lever to reach its lowest position so that it cannot
maintain tension on the strip. If this occurs, follow
the above procedures to reset the take-up lever.
Figure 6-10
7.0 Electrical connections
All electrical connections must
be done by a qualified electrician in compliance
with all local codes and ordinances. Failure to
comply may result in serious injury.
The JWDS-1632 and JWDS-1836 Sander are rated
at 115-volt power only. The sander comes with a
plug designed for use on a circuit with a grounded
outlet that looks like the one pictured in Figure 17.
Before connecting to power source, be sure switch
is in off position.
It is recommended that the sander be connected to
a dedicated 20 amp circuit with circuit breaker or
fuse. If connected to a circuit protected by fuses, use
time delay fuse marked “D”. Local codes take
precedence over recommendations.
7.1 GROUNDING INSTRUCTIONS
This machine must be grounded. In the event of a
malfunction or breakdown, grounding provides a
path of least resistance for electric current to reduce
the risk of electric shock. This tool is equipped with
an electric cord having an equipment-grounding
conductor and a grounding plug. The plug must be
plugged into a matching outlet that is properly
installed and grounded in accordance with all local
codes and ordinances.
Do not modify the plug provided - if it will not fit the
outlet, have the proper outlet installed by a qualified
electrician.
Improper connection of the equipment-grounding
conductor can result in a risk of electric shock. The
conductor with insulation having an outer surface
that is green with or without yellow stripes is the
equipment-grounding conductor.