Product Manual

25
10.0 User-maintenance
Before any intervention on the
machine, disconnect it from the electrical
supply by pulling out the plug. Failure to comply
may cause serious injury.
Clean band saw regularly to remove any resinous
deposits and sawdust.
Keep miter slot, and guide bearings, clean and free
of resin.
Keep blade clean and sharp. Check it periodically
for cracks or other signs of wear.
The drive belt should be checked periodically. If it
looks worn, frayed, glazed or otherwise damaged,
replace it.
Check that the cleaning brush over the band wheel
is working properly, and remove any deposits from
the band wheels to avoid vibration and blade
breakage.
Do not let saw dust build up in the upper and lower
wheel housings. Vacuum or blow out dust from
inside cabinet. (Use proper dust mask equipment).
The table surface must be kept clean and free of rust
for best results. If rust appears, it can often be
removed with a mixture of household ammonia,
good commercial detergent and #000 steel wool.
Alternatively, commercial rust removers can be
found at many hardware stores.
Apply a light coat of paste wax to the table surface.
Aerosol protectants are also available in major
hardware stores and supply catalogs. Whatever
method is chosen, the coating should protect the
metal and provide a smooth surface, without
staining workpieces.
If the power cord is worn, cut, or damaged in any
way, have it replaced immediately.
Connect the band saw to a JET dust collection
system of appropriate capacity.
Vacuum out the motor fan cover.
10.1 Lubrication points
1. Periodically apply a light, non-hardening grease
to rack and pinion system of guide post.
2. Grease sliding surfaces of the table trunnions.
3. Oil any pins, shafts, and joints. (Do not get oil
on pulleys or belts.)
4. Clean and oil the tensioning mechanism if it
becomes difficult to adjust.
Note: Bearings on the band saw are pre-lubricated
and sealed, and do not require attention.
10.2 Additional servicing
Any other servicing should be performed by an
authorized service representative.