Use and Care Manual
Table Of Contents
- JJP-8BT Jointer-Planer
- 1.0 Warranty and Service
- 2.0 Table of contents
- 3.0 Safety warnings
- 4.0 Features
- 5.0 Specifications
- 6.0 Setup and assembly
- 7.0 Assembly
- 8.0 Jointer setup
- 9.0 Planer setup
- 10.0 Operating controls
- 11.0 Adjustments
- 12.0 Basic Operations
- 13.0 Maintenance
- 14.0 Lubrication
- 15.0 Optional Accessories
- 16.0 Troubleshooting the JJP-8BT
- 17.0 Replacement Parts
- 17.1.1 Jointer/Planer – Parts List
- 17.1.2 Assembly Drawing Index
- 17.1.3 Planer Table Assembly
- 17.1.4 Motor Assembly
- 17.1.5 Front Frame Assembly
- 17.1.6 Chain Drive Assembly
- 17.1.7 Front Cover Assembly
- 17.1.8 Cutterhead Guard Assembly
- 17.1.9 Dust Cover Assembly
- 17.1.10 Jointer Infeed Table Assembly
- 17.1.11 Jointer Outfeed Table Assembly
- 17.1.12 Cutterhead/Feed Roller Assembly
- 17.1.13 Jointer Fence Assembly
- 17.1.14 Rear Frame and Cover Assembly
- 17.2.1 Jointer/Planer Stand – Parts List
- 17.2.2 Jointer/Planer Stand – Exploded View
- 18.0 Electrical Connections – JJP-8BT
8
6.3 Contents of stand
The stand is not included but is an optional item
available for purchase. To purchase, call Customer
Service at the phone number on the cover of this
manual. The following instructions are included if
you have purchased the stand or will purchase one
at a later date.
Compare the contents of the carton against the list
of parts below.
Contents of Stand Carton
02 Long Support Plate – SA
02 Short Support Plate – SB
02 Long Stand Top Support – SC
02 Short Stand Top Support – SD
04 Stand Leg – SE
Stand Hardware
(included in Hardware Package, p/n JJP10BT-HP)
Note: The index number in parentheses refers to
the same item as shown in the parts breakdowns.
04 Hex Cap Screw, M6x20 (#13, Stand Assbly) –
SF
24 Carriage Bolt, M6x12 (#9, Stand Assbly) – SG
28 Flat Washer, 6mm (#8, Stand Assbly) – SH
24 Lock Washer, 6mm (#7, Stand Assbly) – SJ
28 Hex Nut, M6 (#6, Stand Assbly) – SK
04 Socket Head Cap Screw, M8x20 (#16, Stand
Assbly)
– SM
04 Flat Washer, M8 (#14, Stand Assbly) – SN
04 Lock Washer, M8 (#15, Stand Assbly) – SP
04 Rubber Foot (#12, Stand Assbly) – SQ
Figure 5 – Contents of Stand Carton
Figure 6 – Stand Hardware
(included in JJP10BT-HP Hardware Package)