Use and Care Manual
Table Of Contents
- 2 x 72-inch Square Wheel Belt Grinder
- 1.0 IMPORTANT SAFETY INSTRUCTIONS
- 2.0 About this machine and manual
- 3.0 Table of contents
- 4.0 Specifications for SWG-series Grinders
- 5.0 Setup and assembly
- 6.0 Electrical connections
- 7.0 Adjustments
- 8.0 Operation
- 9.0 User-maintenance
- 10.0 Optional accessories
- 11.0 Troubleshooting SWG-series Square Wheel Grinders
- 12.0 Replacement Parts
- 12.1.1 SWG-272 Square Wheel Belt Grinder – Exploded View
- 12.1.2 SWG-272 Square Wheel Belt Grinder – Parts List
- 12.2.1 SWG-272 Motor Assembly – Parts List and Exploded View
- 12.3.1 SWG-272 Push Button Switch Assembly – Parts List and Exploded View
- 12.4.1 SWG-272VS Square Wheel Belt Grinder – Exploded View
- 12.4.2 SWG-272VS Square Wheel Belt Grinder – Parts List
- 12.5 SWG-272VS Motor Assembly – Parts List and Exploded View
- 12.6 SWG-272VS Control Switch Assembly – Parts List and Exploded View
- 12.7 Idler Housing Casting Assembly (all models) – Parts List and Exploded View
- 12.8 Platen Assembly (all models) – Parts List and Exploded View
- 12.9 Contact Wheel Assembly (all models) – Parts List and Exploded View
- 12.10 Dust Hood Assembly (all models) – Parts List and Exploded View
- 13.0 Electrical Connections
- 14.0 Warranty and Service
12
8.1.2 Single speed model (SWG-272)
See Figure 8-2.
Pull the red “mushroom” switch outward to start
machine. The green light will illuminate. Push back
in to stop machine; green light will turn off.
To prevent accidental or unauthorized operation,
stop the machine and pull out the yellow safety key.
The key must be reinserted to start the machine.
(Push key all the way in until a “snap” sound is
heard.)
Figure 8-2: standard control
8.2 Typical uses for the Square Wheel Belt Grinder
Figure 8-3