Use and Care Manual

JET
3
23. Shut off air supply and discharge any residual
pressure from tool before removing hose,
making adjustments, changing accessories,
or storing tool.
24. Make sure tool is switched off, and your finger
off the trigger, before connecting to air supply.
25. Remove adjusting keys and wrenches before
turning on tool.
26. Keep visitors a safe distance from the work
area. Keep children away.
27. Give your work undivided attention. Looking
around, carrying on a conversation and
“horse-play” are careless acts that can result
in serious injury.
28. Do not force a tool or attachment to do a job
for which it was not designed. The right tool
will do the job better and more safely.
29. Repetitive motions and/or exposure to
constant vibration can be harmful to hands
and arms. Take frequent breaks and relax
hands during extended operation. Change
posture to avoid discomfort or fatigue.
30. Compressed air can be harmful if directed
toward sensitive areas of the body, and may
propel small particles caught in the air stream.
Exercise proper caution.
31. Use only recommended accessories;
improper accessories may be hazardous.
32. Maintain tools with care. Keep air tool clean
and oiled for best and safest performance.
33. Do not use combustible gases, carbon
dioxide, oxygen or any bottled gas as an air
source for the tool. These can present risk of
explosion and serious injury.
34. Do not lubricate the tool with combustible
liquids, such as kerosene, diesel or jet fuel.
35. Do not dispose of this tool with normal
household waste. Never dispose of the air tool
into fire.
Specific warnings for Cut-off tool
36. If you are not familiar with the proper and safe
operation of a pneumatic cut-off tool, do not
use until proper training and knowledge have
been obtained.
37. Speed rating of cutting disc must equal or
exceed rated free speed of cut-off tool.
38. Inspect cutting discs for cracks or stress.
Never use a damaged disc.
39. Make sure disc is secured on tool before
operating.
40. Make sure workpiece is secure and will not
shift while operating cut-off tool. Do not hold
workpieces with your hand.
41. Keep hands away from disc and guard during
operation.
42. Do not operate without guard attached and
properly positioned.
43. Use only cutting discs of proper size for this
tool. Do not modify a disc or use bushings,
flanges, etc., to mount a disc of incorrect size.
44. Disc must rotate in opposite direction to
direction of feed.
45. Avoid jamming, twisting, or pinching cutting
disc in workpiece.
Familiarize yourself with the following safety notices used in this manual:
This means that if precautions are not heeded, it may result in serious, or even
fatal, injury.
This means that if precautions are not heeded, it may result in minor injury and/or
possible tool damage.