Use and Care Manual
Table Of Contents
- L-100 Series Hand Chain Hoists
- 1.0 IMPORTANT SAFETY INSTRUCTIONS
- 2.0 Table of Contents
- 3.0 Introduction
- 4.0 Specifications
- 5.0 Using the Chain Hoist
- 6.0 Hand Chain – Cutting and Installing
- 7.0 Load Chain and Bottom Hook
- 7.1 Load Chain Inspection (all models)
- 7.2 Load Chain Removal (all models)
- 7.3 Attaching Load Chain to Load Chain Sprocket (all models)
- 7.4 Load Chain and Bottom Hook Installation
- 7.5 Chain Installation: 0.5- to 2-Ton Hoists
- 7.6 Chain Installation: 3- to 5-Ton Hoists
- 7.7 Chain Installation: 10- to 20-Ton Hoists
- 8.0 Overload Protection
- 9.0 Inspection and Maintenance
- 10.0 Load Limits
- 11.0 Troubleshooting JET® Manual Chain Hoists
- 12.0 Timing Marks for Gear Replacement
- 13.0 Replacement Parts
- 13.1.1 L-100 Chain Hoist Parts Breakdown
- 13.1.2 Parts List: L100-25 Chain Hoist (0.25 Ton)
- 13.1.3 Parts List: L100-50 Chain Hoist (0.5 Ton)
- 13.1.4 Parts List – L100-100 Chain Hoist (1 Ton)
- 13.1.5 Parts List – L100-150 Chain Hoist (1.5 Ton)
- 13.1.6 Parts List – L100-200 Chain Hoist (2 Ton)
- 13.1.7 Parts List – L100-300 Chain Hoist (3.0 Ton)
- 13.1.8 Parts List – L100-500 Chain Hoist (5 Ton)
- 13.1.9 Parts List – L100-1000 Chain Hoist (10 Ton)
- 13.1.10 Parts List – L100-1500 Chain Hoist (15 Ton)
- 13.1.11 Parts List – L100-2000 Chain Hoist (20 Ton)
- 14.0 Warranty and Service
4
3.0 Introduction
This manual is provided by JET covering the safe operation and maintenance procedures for a JET
Model L-100 Series Chain Hoist. This manual contains instructions on installation, safety precautions,
general operating procedures, maintenance instructions and parts breakdown. This hoist has been
designed and constructed to provide consistent, long-term operation if used in accordance with
instructions set forth in this manual. If there are any questions or comments, please contact either your
local supplier or JET. JET can also be reached at our web site: www.jettools.com.
The L-100 Chain Hoist complies with ANSI/ASME B30.16 and HST-2 standards.