Installation Guide

ManualsBrandsJESCO Lighting ManualsKitchenArchitectural 1-Light Opal White Cased Glass Pendant

INSTALLATION INSTRUCTIONS

JC 01/10/2012

Architectural Pendants

When installing or using this luminaire, basic safety precautions should always

be observed including the following:

CAUTION - RISK OF FIRE

MAXIMUM WATTAGE AS MARKED ON LUMINAIRE MUST NOT BE EXCEEDED

1. Read and understand instructions completely before installing this luminaire.

2. This product must be installed in accordance with the applicable NEC and local codes by a

person familiar with the construction and operation of the product and the hazards involved.

3. To prevent electrical shock, turn off electricity at fuse box before proceeding.

4. Suitable for damp locations.

5. Save these installation instructions and refer to them when modications or lamp

replacements are made.

IMPORTANT SAFETY INSTRUCTIONS

66-25 Trafc Avenue • Glendale NY 11385

Tel: 718.366.3211 Fax: 718.366.3646

219 South 6th Avenue • City of Industry • CA 91746

Tel: 626.333.3661 Fax: 626.333.2955

jescolighting.com

Technical Support: 855.592.0029

Email:support@jescolighting.com

Summary of content (4 pages)

PAGE 1
JC 01/10/2012 INSTALLATION INSTRUCTIONS Architectural Pendants IMPORTANT SAFETY INSTRUCTIONS When installing or using this luminaire, basic safety precautions should always be observed including the following: 1. Read and understand instructions completely before installing this luminaire. 2. This product must be installed in accordance with the applicable NEC and local codes by a person familiar with the construction and operation of the product and the hazards involved. 3.
PAGE 2
JC 01/10/2012 INSTALLATION INSTRUCTIONS Architectural Pendants Note: Installation steps and components may vary depending on various types of custom installation SUSPENSION CANOPIES Rod Suspension Cord Suspension Aircraft Cable Suspension with Ballast Housing Aircraft Cable Suspension Upper Rod Lower Rod CANOPY INSTALLATION 1. 2. 3. 4. 5. Turn off power at the fuse or circuit breaker panel. Route wires from the J-Box through the mounting plate (Fig A). Attach mounting plate to J-Box (Fig A).
PAGE 3
JC 01/10/2012 INSTALLATION INSTRUCTIONS Architectural Pendants Note: Installation steps and components may vary depending on various types of custom installation PENDANT ASSEMBLY & INSTALLATION 1. 2. 3. 4. If using aircraft cable suspension, install husk onto crown first (Fig C). If using lens bracket, attach to husk using supplied screws (Fig D). If using hood, slide hood over reflector/refractor/diffuser before mounting to husk (Fig E).
PAGE 4
JC 01/10/2012 INSTALLATION INSTRUCTIONS Architectural Pendants Note: Installation steps and components may vary depending on various types of custom installation SUSPENSION MODIFICATION & INSTALLATION Rod Suspension Modification 1. Pull wires out of rod(s). 2. Use hacksaw to cut the upper rod (rod with holes on one end) to desired length and discard end with holes (Fig K). Note: if only using the lower rod for hanging, cut the side of the rod with inner threads, not the husk connector. 3.