Instructions / Assembly

INSTALLATION INSTRUCTIONS
MODEL: 52WH184PV
RECESSED MOUNTED,
STEEL MEDICINE CABINET
For help, call us tollFor help, call us toll
For help, call us tollFor help, call us toll
For help, call us toll
free!free!
free!free!
free!
1-800-637-14531-800-637-1453
1-800-637-14531-800-637-1453
1-800-637-1453
INSTALLATION of CABINET
1. Carefully remove all packing material. Place hardware
packages, shelves and door aside until needed. Hardware
and shelves are located in the fillers identified by
“Hardware enclosed” tape.
2. Determine desired location of cabinet on wall. Mark wall to
show wall opening size (see dimension chart). Generally,
the recommended height to the center of the cabinet is 64”
from the floor. (Fig. 1)
3. CAUTION: Wall studs, plumbing or electrical lines that
interfere must be removed or relocated. Cut wall opening,
being careful not to damage the surrounding wall surface.
Insert framing to support all plaster board edges.
4. Prepare the mounting screws (#8 x 1
1
/
2
”) by placing the
screws into the clear plastic bases. (Fig. 2)
5. Note: For ease of installation, an additional person is
recommended. Insert cabinet into wall opening. (Fig. 3)
Ensure the cabinet is plumb and level. If necessary use a
carpenter’s level and shim corners of cabinet. Secure to
wall studs through the four (4) mounting holes inside
cabinet, using the screws that have been placed into the
plastic bases. (Fig. 4) Do not over tighten the mounting
screws as the body wall may bend and prevent proper shelf
installation. Only tighten screws until they are flush with
the body.
6. Snap the screw covers over the screw bases. (Fig. 5)
INSTALLATION of DOOR
1. Remove the two (2) 2
1
/
2
” screws from the hardware bag
and place into the two (2) remaining clear plastic bases.
Drive the screws through the holes in the hinge, drywall
and into wall framing for additional mirror support. (Fig. 6)
2. Snap screw covers over the screw bases. (Fig. 5)
3. Remove the hinge pin from the cabinet hinge - position the
mirror to the body and secure with hinge pin. (Fig. 7)
4. Remove the striker plate from parts bag, remove the paper
backing and position with face against the magnet. Close
the door and apply pressure against door to seat striker
plate to door.
MODEL WALL OPENING OVERALL SIZE
NO. W H D W H D
52WH184PV 14
1
/
4
18 3
1
/
2
21
1
/
4
31
1
/
4
4
1
/
2
INSTALLATION of SHELVES, HOLE PLUGS AND
BUMPERS
1. Select where you want the shelves to be placed.
2. Insert two (2) shelf brackets at each end of the shelf
location. (Fig. 8)
3. Set shelves in place on the shelf brackets, pressing down
on shelf to lock in place. (Fig. 8)
4. Remove hole plugs from hardware bag and place in
remaining holes. ( Fig. 9)
5. Remove bumpers from hardware bag and position to body.
(Refer to Service Parts Drawing - Key No. 11 for bumper
locations)
Fig. 3
Fig. 4
Fig. 6
Fig. 1
Insert screw
through clear
plastic base
Snap on Cover
Cover
Base
Screw
Fig. 2
Fig. 5
Fig. 7
Fig. 8
Fig. 9