Product Manual

21
9.) Inspect all tubing and piping for loose connections or damage.
10.) Check all accessories for damage and loose mountings.
SERVICING NEW EQUIPMENT
1.) Remove the unit from the shipping pallet and place on a level surface.
This can be accomplished by removing the shipping bolts or bands located at the four corners of the
base weldment or receiver tank.
2.) Check oil level in pump, safety relief valve operation, air fi lter cleanliness, air receiver
condensate as specifi ed in Section 4.
3.) Perform all the preventive maintenance servicing as specifi ed in Section 5 of this manual.
LUBRICATION
If the unit is portable, lubrication of the wheels may be required. Use a high quality standard
grease. Maintain proper oil level in the compressor pump and gasoline engine if so equipped.
AIR CLEANER
The air cleaner is of the dry, replaceable type. One of the most important service requirements
for long term maintenance free operation is to replace or clean the air cleaner element regularly.
Excessive wear, high oil consumption and poor performance will
result if the air cleaner is clogged or allows contamination to enter
the compressor. Refer to maintenance instructions in Section 4 for
service instructions and intervals for cleaning or replacement of
element.
INSTALLATION
Proper installation is a key factor in determining the longevity of an air compressor. Please study the
installation information in this manual. This information is a guideline for a typical shop installation
and is not all inclusive. If there are questions concerning the installation, please do not hesitate to
contact your Jenny representative or the Jenny Compressor Company if additional information is
required.
1.) Position compressor and receiver tank in a safe work area.
Place the compressor and receiver in the designated work area. Leave a minimum of 3 feet
clearance around the unit for work space.
NOTICE