Installation Instruction

5
2. Secure the side wooden blocks to the side walls of the
cabinet and wooden bottom spacer so that the coffee
system can be installed as per the Installation Instructions.
3. After securing the 'blocks', the distance between them
should be 22
1
/
16
" (55.97 cm). If the distance between the
mounting brackets is greater than 22" + 1⁄16" (55.9 +
0.07cm), bracket spacers will need to be used. Four 1 mm
bracket spacers are included. See Step 4.
4. If bracket spacers are needed: Position the necessary
spacer(s) behind the mounting brackets. Continue with Step
5.
5. Determine where the mounting brackets will be installed and
mark 6 holes through each mounting bracket onto the side
cabinet.
IMPORTANT: The front of the mounting bracket must be
1/16" (2 mm) from the front fascia thickness of the cabinet
frame.
Align the front of the mounting brackets 13/16" (2.1 cm) back
from the front of the cabinet and mark 6 holes through each
mounting bracket onto the blocks.
6. Using a 1/16" (2 mm) drill, drill the holes marked in Step 5.
7. Secure the mounting brackets to the side cabinets with six
3/16" x 5/8" (4.5 x 16 mm) screws in each bracket.
8. Remove the tape holding the brackets in place.
9. Pull the runners forward until they are fully extended and in
the locked position. Place level across the runners and check
levelness. Then place the level along the length of each
runner and check levelness from front to back. If the runners
are not level, uninstall the mounting brackets and raise or
lower the mounting brackets as necessary until they are
level.
NOTE: If the runners are not level, uninstall the mounting
brackets and raise the mounting brackets as necessary
using the metal shims provided, until they are level.
10. If the coffee system is being installed above a wooden
cabinet bottom, use two 3/16" x 5/8" (4.5 x 16 mm) screws
to install the metal trim piece at the front edge of the cabinet
bottom.
22 + 1/16"
(55.9 + 0.07 cm)
22 + 1/16"
(55.9 + 0.07 cm)
A
A
A. Bracket spacers
A. Front of mounting bracket 1/16" (2 mm)
from outside of cabinet frame
B. Mark 6 screw holes.
B
A
B
1/16" (2 mm)
x 4
A
A. Metal trim piece