installation manual

18
6. Pull the grill orice holder out of the burner box to allow
access to the orice with a wrench, being certain not to kink
the attached tubing.
7. Using an adjustable wrench and a 1/2" (1.3 cm) open end
wrench remove the Propane (L) orice spud and replace with
the correct Natural Gas (NG) orice spud. See Natural Gas
Orice Spud Chart.
8. Reposition the grill orice holder assembly back into the
burner box, and replace the grill orice holder bracket and
two holder screws.
9. Lift up on the control console and set it back into place. For
a proper t, the ange of the control console must hook over
the lip on the front of the cooktop.
NOTE: The side ange of the console aligns outside of the
cooktop box, but inside the side rail ange.
NOTE: It may be necessary to lift valve stems to align with
console holes.
10. Check that the control console is ush with the top edge of
the cooktop.
11. Replace the screws on each side of the control console.
12. Replace the control knobs and bezels.
13. Replace burner grates.
14. Reconnect power.
Complete Installation
1. Refer to the “Make Gas Connection” section for properly
connecting the cooktop to the gas supply.
2. Refer to the “Electronic Ignition System” section for proper
burner ignition, operation, and burner ame adjustments.
Checking for proper cooktop burner ame is very important.
The small inner cone should have a very distinct blue ame
1/4" (6.4 mm) to 1/2" (1.3 cm) long. The outer cone is not as
distinct as the inner cone. Propane gas ames have a slightly
yellow tip.
3. Refer to “Complete Installation” in the “Installation
Instructions” section of these instructions to complete this
procedure.
A
B
A. Grill orifice
B. Grill orifice holder
Use 1/2" (1.3 cm)
open end wrench
to remo
ve/replace
orifice
Hold with adjustable
wrench here
A
B
C
A. Side rail flange
B. Console side flange
C. Cooktop box
A
B
A. Control console flange
B. Front lip of range cooktop
A
A. Flush with range top