Installations Sheet

INSTALLATION INSTRUCTIONS

Remove Mounting Plate

Depending on your model, the mounting plate may

be in the foam packaging, or it may be attached

to the back of the microwave oven.

NOTE: To avoid possible damage to the work surface,

cover the work surface.

1. Remove any remaining contents from the microwave

oven cavity.

2. If the mounting plate is attached to the back of

the microwave oven, remove it and set it aside.

3. Tape the microwave oven door closed so that door does

not swing open while the microwave oven is being handled.

NOTE: To avoid damage to the microwave oven, do not grip

or use the door or door handle while the microwave oven

is being handled.

Rotate Blower Motor

The microwave oven is set for recirculation installation. For wall

or roof venting, changes must be made to the venting system.

NOTE: Skip this section if you are using recirculation installation.

Keep the damper assembly in case the venting method

is changed or the microwave oven is reinstalled in another

location where wall or roof venting may be used.

Wall Venting Installation Only

1. Remove screws attaching damper plate to top of microwave

oven exterior. Slide damper plate toward the front of the

microwave oven and lift up.

2. Keep damper plate and screws together and set aside.

3. Remove 2 screws attaching blower motor to back

of microwave oven.

4. Lift blower motor out of microwave oven.

5. Rotate blower motor 180° so that exhaust ports face

the back of microwave oven, and lower blower motor

back into the microwave oven.

A. Screws

B. Damper plate

A. Screws (in recessed holes)

A. Blower motor

A. Exhaust port