Instructions / Assembly

Please visit jeld-wen.com for warranty
and care and maintenance information.
Thank you for choosing
©2018 JELD-WEN, inc.; This publication and its contents are owned by JELD-WEN, inc. and are protected under the U.S. Copyright Act and other intellectual property laws. All trademarks, service marks, logos
and the like (whether registered or unregistered) are owned or controlled by JELD-WEN, inc. or others. Unauthorized use or duplication of JELD-WEN intellectual property is prohibited.
JELD-WEN reserves the right to change product specications without notice. Please check our website, jeld-wen.com, for current information.
10/01/18
Installation Instructions
for Interior Door Slabs (JII110)
4
COMPLETE INSTALLATION
Install Lockset and Finish Installation
1. The center of the hole for
the lockset is usually 44"
from the top of the slab
and either 2 3/8" or 2
3/4" on center from the
edge, depending on the
latch. For slabs that have
a rail (horizontal member)
across the center of
the slab, the lockset
should be centered
in this rail. Using the
lockset manufacturer’s
instructions and
template, drill for lockset.
Generally, a 2 1/8" diameter hole is needed for the lockset. Drill a 1"
latch hole through the edge of the slab into the center of the lock hole
to accommodate the latch for the lock. Some latches have a radius
(rounded corners) or rectangular face plate that will require the slab
edge to be chiseled for t. Drill pilot holes for attachment screws. Other
latches are round (contractor drive-in) and can be tapped into place
with a hammer.
2. Close slab and check for proper operation. Adjust as necessary.
3. Finish all surfaces of the slab if not already done.
4. If installing a solid core,
premium composite or
stile and rail slab, install a
#9 x 2 1/2" screw in the
center hole (as shown)
in the top two hinges
(through the leaves
toward the jamb).
Lockset
hole
Rail
Panel
Latch
hole
2 3/8"
Jamb
Replace with
longer screw