Instructions / Assembly

ManualsBrandsJELD-WEN ManualsBifold Doors36 in. x 80 in. Conmore Juniper Stain Smooth Hollow Core Molded Composite Interior Closet Bi-Fold Door

INSTALLATION INSTRUCTIONS

for Bi-Fold Doors (JII103)

INSTALLATION FOR TYPE E

A. Upper pivot plate (2)

B. Hanger

C. Snugger

D. Knob

E. Lower pivot pin

F. Lower bracket

G. Top pivot bracket

H. Aligner

I. Track

J. Adjustment wrench

Screws (not shown)

PARTS INCLUDED

1. Fasten the pivot

plates to each

door panel with

the 1 1/4" pan

head screws in the

locations shown.

Use the 1" at head

screws on the lower

pivot pin. Center

each plate on the

panel.

2. Trim track to t

nished opening.

3. Install top pivot

bracket into one

end of the track with the pin toward the end and 2 1/4" in. From

the other end, install the hanger and snugger (with rubber bumper

toward hanger) into track.

4. Position overhead

track in the opening

with the open

side down and

the bracket end

toward the jamb.

Allow 3/4" between

the front of the

opening and the

track and drive the

provided 1 1/4"

pan head screws

through the pre-

drilled holes until

snug. Position the

lower bracket on

the oor in line with overhead track. Fasten to the jamb with a 1 1/4"

at head screw through the middle of the top slotted hole.

5. Unlock the track

pivot plate by

pulling the latch

away from the

bracket. With the

door assembly

folded, place the

pin from the top

pivot bracket into

the pivot plate on

the pivot door. Slide

the pin into the

pivot plate and slide

the latch to lock the

pivot plate to the

bracket. Verify the

pin is secure. In the

same manner, lock

the hanger into the

pivot plate on the

lead door.

6. On the bottom,

depress the arm on

the lower bracket

and insert the lower

pivot pin.

To adjust horizontally:

7. At the top, loosen

the screw in the

top pivot bracket

and move toward

or away from the

jamb until there

is 1/4" clearance.

Retighten. Repeat

the process for the

lower bracket.

To adjust vertically:

8. There should be a

slight gap between

the lower pin and

the bracket. If there is no gap or the gap is too large and allows the

pin to come out of the bracket, loosen the single screw in the bracket

and adjust up or down until there is a small gap and the pin is

engaged in the bracket. When the bracket is properly adjusted, install

the remaining two screws and tighten.

9. Loosen the screw on the snugger and close doors. Move until the

snugger contacts the guide pin. Open doors and move an additional

1/8" and tighten screw. Doors should slightly “snap” shut, but reopen

easily with a tug on the knob.

10. Adjust the snugger by closing doors, loosen screw and slide against

guide in track. Open doors and move snugger 1/8" closer to panels

and tighten screw.

Continue with Section 8, “COMPLETE INSTALLATION.”

Horizontal

adjustment

screw

Lower

Bracket

arm

Gap

Snugger

Pivot door

Lead door

Bottom of

pivot door

Top pivot

bracket

7/8"

2 1/4"

5/8"

7/8"

Unlock

Lock

Horizontal adjustment

screw

Track

Center

3/4"

Head

Jamb

Lower

bracket