Instructions / Assembly

INSTALLATION INSTRUCTIONS
for Swinging French and Patio Doors (JII105)
4
2. Mark a line across
the front and back
of the sill pan.
3. Apply three 3/8"
beads of sealant
between the lines.
4. Place the sill pan in
the rough opening.
Firmly press the sill
pan into the sealant
with a J-roller.
1. Set the sill pan
in the rough
opening, aligning
the front edge (for
continuous slab) or
folded down edge
(for step down)
with the exterior of
the rough opening.
4
INSTALL SILL PAN
Sealant
5
PREPARE BUCK
5. For step-down
landings, cut 1/2" in
at this line on both
sides of the sheet
material.
6. For continuous slab,
cut across the folding
line.
'PMEUIFUISFFCBDL
sides up to make a
3-sided box, and, for
step-down landings,
fold the front ap
down.
1. Cut a piece of sheet
material to the
length shown.
2. Lightly crease
folding lines 1/2" in
from the two short
sides and one long
side.
3. Measure the width
of the frame from
the interior to the
nailing n/trim and
BEE
4. Take this distance
from the back edge
and lightly crease a
folding line across
the sheet material.
PREPARE SILL PAN
3
Note! This section applies to installations into a buck only. For
installations into a stud-framed wall, begin with section 6, “PREPARE
STUD-FRAMED WALL.”
1. Seal any joint larger than 1/16" (1.5 mm) in the buck and between
the buck and the concrete/masonry with sealant.
2. Cover the buck and the surrounding concrete/masonry at the head
and jambs and sill with liquid applied ashing as shown.
3. Apply diamond lath to all ashed surfaces to be covered by stucco.
END of Buck Instructions, SKIP to section 7, “INSTALL DOOR.”
Sealant joints
Diamond lath
Liquid applied
ashing
Frame
width

Folding Line
Length of rough opening sill plus 1"
1/2"
1/2"
Measure
frame
width
Interior
Continuous slab
Step down
Fold sides and back up
Fold corner
forward
Fold front
ap down