Owner's manual

SERVICE SUPPLEMENT
Builders Vinyl Sliding Patio Door Handing Reversal (SVC001)
2
5.Prybothanti-
lifts from header
with at head
screwdriver.
6.Flipframe(topto
bottom).
7. Gently pry out the
frame dust plugs
in both ends of the
sill with at head
screwdriver and
install these in the
corresponding holes
intheheadjamb.
SWITCH ROLLERS AND LOCK
1. Lay the panel on a at padded surface.
2. Remove attachment screw (top screw on each roller) from the roller
on each end of the panel and remove.
3.Atotherendofpanel,prythedustplugsfromrollerscrewholeswith
at head screwdriver. Install both rollers on the opposite end of the
panel.
4.Atoppositeend,installdustplugs(twoateachendwith1/2"inlarge
holesand1/4"insmallholes)intopreviousrollerscrewholes.
5.Ifthehandleispre-
installed, remove the
2"machinescrews
from interior handle
set and remove both
handles and handle
lever.
Note: Step 6 must be
performed with the
panel in a horizontal
position to keep the
lock reinforcement
bar from falling down
inside the panel.
6.Pullhookoutto
lockedpositionwithngersorpliers.Maintaingriponlatchhookto
keep lock from falling inside stile.
7. Remove both phillips screws to remove lock.
8.Removeandturnlockoverandreinstallwithhookfacingthe
opposite direction.
9.Reinstallthehandleleverontheinteriorandthenbothhandles.
REMOVE SCREEN - CONTINUED
Note: Do not damage
track when removing;
this may result in poor
screen operation.
3.Griponeendofthe
screen track with
pliers and lift up
carefully to remove.
REMOVE OPERATING PANEL
1. Completely open operating panel to clear anti-lifts in the header.
2.Rolleradjustment
screws are at
both bottom ends
of the panel.
With a phillips
screwdriver, turn
the bottom screw
counterclockwise to
retract rollers and
lower the panel.
3.Fromtheinterior,
lift panel bottom up
and over sill track
and pull inward (if
needed, insert a
large putty knife
between the track
and the rollers to
help lift over the
track).
Note: Do not damage
track or metal track cover when removing track; this may result in poor
operation.
4. Grip one end of the
operating panel track
with pliers and lift up
carefully to remove.
Attachment
screw
Adjustment
screw
Operating
panel track
Anti-lift
block
Dust
plug
Lock
hook
Handle
lever
Interior
handle
Exterior
handle
Attachment
screws