Instructions / Assembly

INSTALLATION INSTRUCTIONS
for Pre-Hung Exterior Entry Doors (JII106)
8
©2011 JELD-WEN, inc.; This publication and its contents are owned by JELD-WEN, inc. and are protected under the U.S. Copyright Act and other intellectual
property laws. All trademarks, service marks, logos and the like (whether registered or unregistered) are owned or controlled by JELD-WEN, inc. or others.
Unauthorized use or duplication of JELD-WEN intellectual property is prohibited.
JELD-WEN reserves the right to change product specications without notice. Please check our website, jeld-wen.com, for current information.
4. Removehexwrench
and try closing
force.
5. Repeatstepsuntil
closing force is
adequate but do
not rotate past
3holeson180
o
openingsor4holes
on90
o
openings.
8
COMPLETEINSTALLATION
1. Fill any nail/screw holes and sand smooth.
2. Finishallsixsidesofthedoorslabaswellastheframe.
3. Installexteriorwallsurfacewithinsevendaysofinstallation.
4. Installlocksethardwarepersuppliedinstructions.
5 Removeprotectivelm(ifapplicable)onglasswithinoneyear.
6 Protect recently installed units from damage from plaster, paint, etc.
by covering the unit with plastic.
7 Installanyinteriortrimasdesired.
(03/11)
Please visit jeld-wen.com/resources for nishing instructions, warranty and care and maintenance information.
Thank you for choosing
7
INSTALLDOOR-CONTINUED
FIRE DOOR INSTALLATION
Please see our separate document for additional requirements
for installing re-rated doors at www.jeld-wen.com/resources.
Automatically closing hinges are required on re doors, so the
appropriate adjustment procedure is as follows:
Adjust spring tension:
1. Closedoor.
2. Inserttheprovidedhexwrenchsothatitcanberotatedclockwise.
3. Rotatehexwrench1/4turnandinserttensionpinlooselyinto
tension hole.
Tension
pin
Tension
hole
Clockwise