Use and Care Guide

5
CLEANING GLASS – CONTINUED
HARDWARE CLEANING AND LUBRICATION
HARDWARE CLEANING
STUBBORN STAIN REMOVAL
Commercial glass cleaning products may be necessary.
• Apply small amount directly to the stain. Avoid spilling or
dripping down the glass.
• Some persistent stains may need higher strength cleaning
solutions that contain active ingredient chemicals such as
denatured alcohol or acetone. Special care must be taken
when using these types of cleaners.
• For oil and grease: try baking soda and water or washing soda
and water.
MORE INFORMATION ON GLASS CLEANING
• The Glass Association of North America (GANA):
www.glasswebsite.com
• Cardinal Glass Industries: www.cardinalcorp.com
Note on Websites! Website content is subject to change and
should be used for informational purposes only. JELD-WEN is not
responsible for third-party information.
Maintain hardware any time windows are not opening or closing
properly or at least bi-annually (monthly for coastal areas) for:
• Clean dirt/debris
• Tighten loose screws
• Replace damaged hardware
PRECAUTIONS
The following substances may damage protective hardware
nishes. Do not use:
• Vinegar-based cleaners
• Citrus-based cleaners (lemon, etc.)
• Paint removers
• Window cleaners
• Brick/siding washes
• Any other industrial or abrasive cleaners
Use caution with silicone-based sprays. Apply only in small
amounts and do not overspray. Wipe off excess lubricant to avoid
staining and/or damage to other window or patio door parts.
Silicone may cause some hard plastic parts to become brittle and
cause problems with nishing or renishing wood surfaces.
HARDWARE TYPES
Metal hardware offers functionality, aesthetic appeal and
resistance to corrosion, but is not totally corrosion proof. Replace
corroded hardware.
Plastic hardware offers high resistance to the elements; however,
over time, can deteriorate from ultraviolet light, heat, cold, and
chemical exposure.
Brass hardware has a special protective lm to reduce/eliminate
polishing and requires special care.
General Cleaning
1. Remove hardware for easier cleaning.
2. Use mild soap and water on a soft cloth or sponge; rinse and
wipe dry. For stubborn dirt, use a soft bristle brush to gently
scrub.
3. Apply several coats of high quality, non-abrasive car wax.
4. Reinstall hardware.
Tarnish Cleaning (Brass Hardware)
This section does not apply to brass-plated hardware. The
following cleaning and polishing procedure is recommended by a
brass hardware company.
1. Carefully remove hardware.
2. Gently clean with extra ne steel wool (No. 0000) soaked in
light oil or mild soapy water.
For tough-to-clean brass hardware:
a. Soak overnight in lacquer thinner or paint reducer.
b. Dry completely.
c. Apply brass polish to dry hardware (follow instructions on
manufacturer’s label).
d. After polishing, apply several coats of high quality, non-
abrasive car wax.
e. Prolong nish with follow-up wax applications.
3. Reinstall hardware.
Heavy Cleaning
Solvents, abrasives, and other cleaners could cause damage to
protective coatings on hardware. If the general cleaning procedure
is not sufcient, call us for recommendations.
Cleaning and lubrication help to maintain and restore smooth operation to movable parts of windows and patio doors and, in most cases,
offer corrosion protection. Always thoroughly clean hardware before lubricating.
CARE AND MAINTENANCE
Wood Windows and Patio Doors (JCM003)