Operating Guide

PRODUCT GUIDE
Wood Patio Doors (JPG012)
4
The head track can
now be pulled out
from above the
operating panel.
6. Tilt the top of the
panel toward the
interior (the head
track will be sitting
on top of the
panel), and lift the
head track from the
top of the panel.
7. Lift the panel up
and over the sill
track.
8. Lay operating panel
on a at surface
with interior side
facing up.
9. For bi-parting
panels, repeat
process for passive
panel.
10. To reinstall panel,
perform removal
steps in reverse
order.
Note! When reinstalling
the Siteline head
parting stop, make sure
the weatherstrip ap
goes down as shown
above.
CARADCO SLIDING
PATIO DOOR
1. Close and lock
operating panel.
2. Unscrew and remove
head stop.
3. Carefully unlock
panel and slide away
from side jamb.
4. Tilt top of panel to
the interior and lift
up and over sill track.
5. To install panel,
perform these steps
in reverse order.
Siteline Sliding Patio Doors
Siteline Sliding Patio Doors
W-2500 Sliding Patio Doors and Caradco
French Manor Doors
Head
track
Exterior
trim
Head
stop
Head
stop
Head
track
Head
track
Screw
Weatherstrip
ap
Operating
panel
Operating
panel
Operating
panel
Stationary
panel
Head
ller
Score
SLIDING/GLIDING PATIO DOOR PANEL REMOVAL AND INSTALLATION - CONTINUED
SITELINE AND W-2500 DOOR WITH FIBERGLASS SILL OPERATING PANEL
1. Close and lock the
operating panel.
2. Pull the bumper
out of the top
interiortrack.
3. Score through
any paint or nish
between the head
trim and door
frame. Gently
remove interior
head trim with
small prying tool
being careful not to
damage the wood.
4. Unlock and open
door all the way
and remove the
exposed screws
from the head track
with a #2 square
drive screwdriver.
5. Close and lock
operating panel
to prevent it from
falling out of the
frame opening.
6. Remove screws from
opposite side of the
head track.
7. Unlock operating
panel and carefully
slide open.
8. Tilt the top of the
panel toward the
interior (the head
track will be sitting
on top of the
panel), and lift the head track from the top of the panel.
9. Lift the panel up and over the sill track.
10. Lay operating panel on a at surface with interior side facing up.
11. To reinstall panel, perform removal steps in reverse order.
STATIONARY PANEL
POZZI (PRE-1996)
Note! Operating panel
must be removed rst.
The head stop should
already be removed.
From interior,
1. Unscrew and remove
the head ller from
operating panel side
of head jamb.
2. Unscrew and remove
the head and sill
brackets.
3. Slide panel away
from jamb, press bottom towards exterior while lifting up, then
remove to interior.
4. To reinstall the panel, perform these steps in reverse order.
Head
trim
Head
track
Screw
Operating
panel
Score
Interior
head trim
Bumper
Head
track
Exterior
trim
Head
stop
Operating
panel
Head
ller
Head
track