How to Guide

PRODUCT GUIDE
Wood Patio Doors (JPG012)
10
SITELINE SLIDING DOOR HANDLE SET REPLACEMENT
When removing screws and parts, keep track of their exact locations
for reinstallation. To replace, follow instructions included with the new
handle set. Compare replacement components to existing hardware to
verify you have the correct replacement part(s).
1. Open panel.
2. Remove screws from
the interior handle.
3. Remove handles
(interior and
exterior), the interior
lock lever and the
exterior keyway lock
(if applicable).
4. Remove the
attachment screws
from the lock
assembly in the
dooredge.
5. Remove the lock
assembly.
6. To remove the lock
strike, mark the
current location
in the jamb and
remove the
attachmentscrews.
7. To install, reverse
these instructions.
LOCK ADJUSTMENT
Make horizontal
adjustment as follows:
1. If necessary, shims
can be ordered and
placed behind the
strike plate. Please
contact us.
Make vertical
adjustments as follows:
1. Loosen the
strikescrews.
2. Adjust the strike up
or down to align
with the latch hooks
and retighten screws.
Attachment
screws
Attachment
screws
Exterior
handle
Handle
lever
Interior
handle
HARDWARE REPLACEMENT AND ADJUSTMENT - CONTINUED
MULTI AND SINGLE-POINT SWINGING DOOR HANDLE SET REPLACEMENT
When removing screws and parts, keep track of their exact locations
for reinstallation. To replace, follow instructions included with the new
handle set. Compare replacement components to existing hardware to
verify you have the correct replacement part(s).
1. Open panel.
2. Loosen set screw
with 4mm allen
wrench from
interior or exterior
handle (only one
handle, not both).
3. Remove handles.
Note! One handle will
remain attached to
the spindle bar.
4. Slide spindle bar
and other handle
out of panel.
5. Remove the screw in the panel edge to remove the dead bolt latch if
present. If there is no attachment screw, the dead bolt latch is xed
to the faceplate and will remove with it.
6. From the interior, unscrew and remove both face plates (they are
connected with the same screw).
7. Unscrew and remove the locking mechanism.
8. To install, reverse these instructions.
SWINGING PASSIVE PANEL LOCK REMOVAL
Note! When removing screws and parts, keep track of their exact
locations for reinstallation.
1. Follow the removal steps in the MULTI AND SINGLE-POINT SWINGING
DOOR HANDLE
SET REPLACEMENT
section above.
2. If the door has
a passive panel
with an astragal,
remove all hardware
fromastragal.
3. Unscrew and
remove astragal
(if weatherstrip
is stapled to the
bottom of the
astragal, pry the
staples out to remove
it) to get to the
locking mechanism
underneath.
4. Unscrew and remove locking mechanism.
New Lock Installation
Note! Align all new parts to the existing screw holes in door panel, and
place the same screws in their previous locations.
1. Install lock mechanism with top ush to top edge of panel.
2. Reinstall astragal (if applicable).
3. Install remaining hardware to previous locations following removal
steps in the Multi-Point Lock Replacement section above in
reverseorder.
4. Test door and lock operation. If not operating properly, check screws
to make sure they are not too tight.
5. Remove and reinstall if necessary.
Multi-Point Swinging Door Lock Replacement
Multi-Point Swinging Door Lock Replacement
Passive
panel
Active
panel
Astragal
Spindle
bar
Face
plate
Dead bolt
latch
Door
handle
Locking
mechanism
Dead bolt
screw
Set
screw
Spindle
bar
Face
plate
Locking
mechanism
Dead bolt
latch
Handle
Siteline Handle and Lock Assembly
Siteline Lock Strike