Installation Guide

ManualsBrandsJELD-WEN ManualsPatio DoorsBlinds Between The Glass Steel Left-Hand Outswing Double Door French Patio Door (Common: 72-in x 80-in; Actual: 71.5-in x 78.6875-in)

INSTALLATION INSTRUCTIONS

for Swinging French and Patio Doors (JII105)

Please visit jeld-wen.com for warranty

and care and maintenance information.

Thank you for choosing

property laws. All trademarks, service marks, logos and the like (whether registered or unregistered) are owned or controlled by JELD-WEN, inc. or others.

Unauthorized use or duplication of JELD-WEN intellectual property is prohibited.

JELD-WEN reserves the right to change product specications without notice. Please check our website, jeld-wen.com, for current information.

(04/15)

COMPLETE INSTALLATION - CONTINUED

Sill extender

Sealant

2. The foam wedges

included with French

and Patio doors are

used to complete the

weatherstrip seal at

each bottom corner

of the operating door

panel(s). Doors will

be provided with

one of two types of

wedges. One has an

upturned L-shaped leg

(shown) and the other

is a simple wedge.

For both types, gently

pull the weatherstrip

ap away from the frame and position the wedge behind the

weatherstrip and against the sill so that the thin edge faces the edge

of the door as it swings closed. Remove the backing paper and stick

the wedge to the frame. Apply a bead of sealant at the intersection

of the jambs, brickmoulds, thresholds and oor as shown.

3. Apply sealant at the

bottom where the

sill meets the frame

on both sides. If a

sill extender is used,

apply a bead of

sealant between the

sill and the extender.

Apply sealant around

any mulls at the

intersection of the

mull and door sill.

4. Apply sealant around

the outside of the

door unit between the

siding and brickmould and between the brickmould and the jamb.

Also apply sealant between the jamb sides and the threshold. Run a

bead of sealant, leaving 1" gaps every 2', along the front side of the

threshold where it meets the slab/rough opening.

5. Create a continuous air seal on the interior between the rough

opening and the frame with low expansion foam.

Sealant

Corner

pad

Exterior

Stop

Interior

COMPLETE INSTALLATION

1. Ensure sealant on back dam of the sill pan fully seals to the inside

face of the sill. Apply more sealant as necessary.

2. Install lockset hardware per supplied instructions.

3. On the exterior of step-down landings, install support trim

underneath the sill where it extends past the landing. Position trim

snugly against the bottom of the sill toe.

4. Fill any nail/screw holes in wood and sand smooth.

5. Finish all six sides of the door panel(s) as well as the frame.

AFTER INSTALLATION

• Install exterior wall surface within seven days of installation.

• Maintain gap of 1/4"-3/8" between door frame and nal exterior wall

surface (siding, stucco, etc.)

• Seal this gap on the sides with backer rod and sealant. For step-down

landings, also seal under the door sill with a discontinuous joint. Do

not apply sealant on top of the drip cap.

• Remove protective lm (if applicable) on glass within one year.

• Protect recently installed units from damage from plaster, paint, etc.

by covering the unit with plastic.

• Install any interior trim as desired.