Use and Care Guide

PRODUCT GUIDE
Interior & Exterior Doors (JPG013)


HARDWARE TYPES

to corrosion but is not totally corrosion proof.
 
it can deteriorate from ultraviolet light, heat, cold, and chemical exposure.

polishing and requires special care.
 
for more information on cleaning and lubricating hardware.

common tasks for any hardware replacement component. Follow these

longer functions properly due to misalignment.
SCREW HOLE REPAIR (IN WOOD ONLY)
1. Cut wooden toothpicks or appropriate sized wood dowel to t screw

2. Fill screw hole with wood glue.

4. Fill to surface with wood putty and let dry.


HARDWARE ALIGNMENT (IN WOOD ONLY)

be tightened. This alignment will create new screw holes.







positions no deeper than screw length.


HINGE REPLACEMENT AND ADJUSTMENT
REPLACEMENT



4. Install new hinge plates in the same locations.

ADJUSTMENT (SPRING HINGES ONLY)
1. Close door.
2. Insert the provided
hex wrench so that
it can be rotated
clockwise.
 

tension pin loosely
into tension hole.
 
and try closing force.
 
closing force is
adequate but do not

o

o
openings.
BLINDS BETWEEN THE GLASS
For easiest operation, keep the slats in a fully open position while operating.
ADJUSTMENTS
1. If the operator comes off of the track, hold the operator at a sharp
angle to the glass and reinsert the two legs under the track opening.

RE-COUPLE OPERATOR MAGNETS

2. Full travel blinds will fully engage when you hear the rst click. Half

continue moving the operator up until you hear the second click. This
will ensure the magnets are fully engaged.
MECHANISM REPLACEMENT


glass to help release the magnets.
2. Tilt the mechanism toward you, and remove the mechanism. It may
require a strong tug to break the magnetic bond.

4. Insert the tabs underneath the lip of the inner frame and raise the
slide to the top until the magnets engage.
a. Full travel blinds will fully engage when you hear the rst click.

you to continue the travel of the operator up until you hear the
second click. This will ensure the magnets are fully engaged.



outside of the glass can do this. The helix tilt operator has a magnet
set which will follow the magnet inside the slide mechanism.
2. Clean the glass attaching area.

4. Before application, push the magnet to the left of the slider. Ensure





adhesive works under pressure.
THRESHOLD ADJUSTMENT (ADJUSTABLE THRESHOLDS ONLY)
Note! Adjusting the threshold may break sealant joints at the ends
and/or interfere with the foam wedges if installed. Adjust threshold,
then replace these components as necessary. See “Foam Wedges” in
the Weatherstrip Replacement section below for details.


screw covers or exposed
screws on the top
where the door slab
contacts the threshold

the sweep properly
contacts the threshold


is needed, use a at
head screwdriver
to remove screw
covers. Turn all screws

up; counterclockwise
to move down until
desired height is
achieved and the
threshold is level.
Tension
pin
Tension
hole
Clockwise

Threshold
Threshold


Threshold