Dimensions Guide

PRODUCT GUIDE
Vinyl Single and Double-Hung Windows (JPG006)
2
NEEDED TOOLS
Note! Each tool is not required for every task.
NEEDED MATERIALS
NEEDED TOOLS & MATERIALS
•Tape measure
•Level
•Putty knife
•Flat head
screwdriver
•Phillips head screwdriver
•Spiraladjustmenttool(ask
your supplier for one) or
locking needle-nose pliers
•Utility knife
•Mini hacksaw
•Needle nose pliers
•Pencil or scribe
•File
•Replacement parts
•String
•Tape
•Scrap wood
SASH REMOVAL & INSTALLATION
A tilt sash has thumb
latches (sash retainer
latches) on the top
two corners of the
sash and can vary in
shape and size.
A side load sash does
not tilt, is removed
from the side, and has
metal take-out clips
inthesidejambjust
above the lower sash.
TILT SASH REMOVAL & INSTALLATION
Note: Double-hung windows require the lower sash be removed before
the upper sash and the upper sash installed before the lower sash.
Label top and bottom sash for reinstallation. The lock is on the bottom
sash.
REMOVAL
1. Opensashatleasthalfway.
2. Press sash thumb latches toward center of window.
•Follow all manufacturers’ instructions and labels.
•Use proper and safe equipment and precautions if servicing the
exterior side of windows above ground level.
•Window insect screens are not security devices and will not prevent
children, other people, or pets from falling through.
•Use extra care when driving screws near glass unit to avoid breakage.
•Use caution when tightening screws to avoid stripping the screw
holes.
PRECAUTIONS & SAFETY
•Sashremovalcanbeawkwardandcouldcausephysicalinjuryor
product damage; we recommend the help of a second person.
•Maintain a strong grip on balance when removing or installing.
Balances are spring-loaded and they will decompress quickly if
released,possiblycausingpersonalinjuryand/orproductdamage.
•Beware of oil causing slippery surfaces.
3. Pullsashtoward
the interior and
hold horizontally
while tilting
out to keep the
balance shoe from
releasing and
popping up. Take
note of which
jambchannelthe
sash is in (the sash
will need to be
reinstalled in the
same channel).
4. Tilt sash toward
interiorata90º
angle.
5. Liftonesideof
sash to release
pivot pin from
balance shoe in the
sidejamb.Notice
thepositionofthebalanceshoeinthesidejambforreplacement.
6. Slightlyswingsashtoremove.
INSTALLATION
1. Insertonepivotpinononecornerofthesashintothebalanceshoe
inthesidejamborslidethepivotpinintothebalanceshoefromthe
topdependingoncongurationofpin/shoecombination.
2. Carefully slide engaged pivot pin and balance shoe downward or
upward until pivot pin on the opposite side can be aligned and
inserted into balance shoe. Sash should be horizontal at this point.
3. Tiltthesashupintoplaceandengageboththumblatches.
4. Test the sash operation. If the sash does not move freely in the
window frame, the pivot pins may not be engaged properly. Remove
and reinstall taking care to engage the pivot pins on both sides.
Thumb
latch
Take-out
clip
Lower
sash