Installation Guide

03/18
Installation Instructions
for Vinyl Windows with Integral Nailing Fin (JII001)
5
INSTALL WINDOW CONTINUED
5
PG20 up to PG35 Fasten window through the nailing n holes
3"-7" from the corners and 12" apart all the
way around the window.
PG35 up to PG50
Awning, Casement,
Fixed, Hung,
Slider, PD
Fasten window through the nailing n holes
3"-7" from the corners and 8" apart all the
way around the window.
PG50 or above
Awning, Casement,
Slider, PD
Fasten window through the nailing n holes
3"-7" from the corners and 8" apart all the
way around the window.
PG50 or above
Fixed
Fasten window through each nailing n hole
(every 4") on the jambs and 8" apart along the
head and sill.
PG50 or above
Hung
Fasten window through the nailing n holes
3"-7" from the corners. Then, install fasteners
12" on center on the jambs, with fasteners
every 4" on both sides of the Interlock. Install
fasteners 8" apart along the head and sill.
Mull Joints The rst 12" beyond mull joints, on both sides,
must be fastened through each nail nhole.
Continuous Head
and Sill PG35
The rst 4" from center, on both sides, must be
fastened every 2".
Continuous Head
and Sill above PG35
The rst 6" from center, on both sides, must be
fastened every 2".
Secure Window
Areas such as Florida and the Texas TDI region have different
anchoring requirements based on product certication. For
information on specic products, visit www.oridabuilding.org
or www.tdi.texas.gov and follow the anchoring schedule given in
the drawings for the product instead of the anchoring schedule in
thisdocument.
NOTE: Fastener (anchor)
heads must be ush. Do
not dent nailing n. Use
the table below to nd the
correct product and fasten it
asdirected.
Window
Window
Mull joint
Nailing
n
#8 x 1 1/4" pan/washer head screw
4"
4" 4"
Mull Example
For PG50 OR ABOVE Tilt Hung Windows ONLY
1. From the interior, just above
the interlock (where the
sashes meet at center), align
with shims and drill a 3/8"
clearance hole through ONLY
the rst wall of the interior
jamb (as shown). This will
allow the screw head to
passthrough.
2. Drive one #8 x 1 1/4" pan/
washer head screw through
the jamb and shim. Repeat for
opposite side.
Opposing
shims
3/8"
clearance
hole
Double-Hung Jamb Cutaway
from Top
Framing
Screw
Nail
n
Jamb
Exterior
See
table
3"- 7"