Instructions / Assembly

INSTALLATION INSTRUCTIONS
for Wood Patio Doors with Exterior Trim or Nailing Fin (JII026)
4
Note! Do not allow gaps or bubbles beneath the ashing (remove and
replace if necessary).
c. Remove the
upper end
corner of each
side piece, and
for step-down
landings,
remove the
lower end
corner.
d. Apply the
side pieces of
self-adhesive
ashing.
e. Remove the
corners of the
header piece
and apply.
3. Apply sealant across
ashing/masonry
joints at corners of
masonry opening.
4. Apply diamond
lath to all ashed
surfaces to be
covered by stucco.
END of Buck
Instructions, SKIP to
section 7, “PREPARE
PATIO DOOR.”
Note! This section covers installations into a buck only. For, stud-framed
wall installations skip to section 6, “PREPARE STUD-FRAMED WALL.”
1. On the exterior,
coat the buck
and surrounding
concrete/masonry
with self-
adhesive ashing
primer. Follow
manufacturer’s
instructions
for application
procedures.
2. Seal the joint
between the buck
and the concrete/
masonry with
JELD-WEN self-
adhesive ashing as
follows:
a. Cut four pieces
of self-adhesive
ashing for the
sill, sides and
head as shown.
b. Apply the sill
pan piece of
self-adhesive
ashing over
the sill pan
as shown. The bottom of the sill pan should be sealed by the
ashing.
2. Mark a line across
the front and back
of the sill pan.
3. Apply three 3/8"
beads of sealant
between the lines.
4. Place the sill pan in
the rough opening.
Firmly press the sill
pan into the sealant
with a J-roller.
If installing into
masonry:
1. Cut a piece of self-
adhesive ashing
the length of the
sill.
2. Cut a notch out of
each end and apply
to the sill as shown.
Both installations:
1. Set the sill pan
in the rough
opening, aligning
the front edge (for
continuous slab,) or
folded down edge
(for step down) with the exterior of the rough opening.
4
5
INSTALL SILL PAN
PREPARE BUCK
Sealant
Top
= Remove for step down only
3"
1.5
Rough opening side jamb +3"
Rough opening head/sill +3"
1.5
3"
Head/Sill piece
Side piece
Side piece