Specification

Connector

Treaded screw

(Not included)

Wrench

(Not included)

Test pencil

Screw driver

Glove

组装所需工具:

Assembly tools required

Put the cover of the box.

Installation Instruction

No.

Check whether the lamp body is damaged

Fasten the T-type hanging plate on the top of the cover and tignten

it.And then lock the screws.

Put the hanging rod in the T-type plate, and fit the screws.

Lock the pin and fix the hanging rod,then fix the screws.

(Please pay attention to the direction of the hanging rod)

Plug the horn shape into the hanging rod.

(Please pay attention to the direction)

Put the bell.(Please pay attention to the direction)

Lock the hanging plate at the top of the hanging rod and then screw it.

Fix the hanging plate in the position where the lamp needs to be hung.

Fix the cover on the bottom of the lamp, and fix it.

Install the crystal shade and the bulbs after the lamp body is

ready.

Remote control: Black-white power input. The first interface connects

ground. "N" means input zero line,"L" means input fire

line. Motor line is divided into three lines:

Pink,Gray,Red. According to the remote control, connect

them in turn, "L" connects live line, "N" connects zero

line, the source line is blue-white.

Light wire

Ground

Input "N"

Input "L"

Grey

Red

Light wire

Motor wire

Pink