Installing Your Fan Safety Precaution IMPORTANT: PLEASE READ BEFORE INSTALLATION 1. Installation must be carried out by a qualified wiring installer. 2. Turn off the electrical mains at the circuit breaker fuse box. 3. When mounting the fan, ensure that the safety cable is loop across the ceiling mounting hook. 4. The ceiling mounting hook must be able to with hold a min of 70 pounds. 5.Do not install the appliance less than 2. 3M from the ground and 1M from the wall to the blades. 6.
Installing Your Fan Tools Required Phillips Flat blade screw over screwdriver Electrical tape Pliers Wire Strippers Power Drill driller Bit ) (optional) (optional) mounting to a support structure you will also need these tools Tools Required If there is no existing mounting box, then read the following instructions. Disconnect the power by removing the fuses or by turning off the circuit breakers Secured the outlet box directly to the building structure. Use appropriate fasteners and building materials.
Installing Your Fan 1. Hanger Options To avoid possible electrical shock, before installing your fan, disconnect the power by turning off the circuit breakers to the outlet box associated with the Wall switch location A 1A.
Installing Your Fan 2. Hanging Motor housing 1.Lift the Motor housing and hang it on the hook of the mounting bracket. (Fig. 3) mounting bracket Motor housing Fig. 3 3. Wiring 1. Wiring according to the wiring diagram. (Fig. 4) FROM CEILING FROM RECEIVER FROM FAN i i white white ite Ase acl yf acl ree blue white white black red red grounding wires grounding wires (FROM CEILING) hi (FROM FAN) (Fig.
Installing Your Fan 4. The receiver installation 1, Put the receiver in the Motor housing after the wire is connected. (Fig. 5) receiver Motor housing (Fig. 5 5. Install ing Motor housing 5.1 Remove two mounting bracket screws. (Fig. 6-1) 5.2 Remove the motor housing from the hook and align it with the mounting bracket hole on the suspension plate, push up and turn Clockwise. (Fig. 5.3 tighten the four mounting bracket screws. (Fig. 6-3) mounting bracket mounting bracket Screws screws Fig. 6-1 Fig.
Installing Your Fan 6.Blade assembly installation 1. Remove blade iron screws from fan motor. (Fig 7) 2. Attach the blade to the motor with blade iron screws. (Fig 7) 3. Repeat this step for each blade assembly. (Fig. 7) blade iron screw Fig. 7 7. Install on light kits the wire through the center hole of the lamp base. (Fig. 9) the lamp base with screws, then connect wire with motor by Wiring cap. then put on the light kit by magnet. (fig. 8 and 9) — 7 lamp base (Fig. 8) (Fig.
Installing Your Fan 8. The lampshade installation 8.1, Install the lampshade to the lamp base by turning clockwise to lock it into place. (Fig 10) lamp base | lampshade (Fig.