User Manual Part 2



7-115


7.4. Configure the WT(slave)
Change the WT’s mode from P-MP to P-P(slave).
On the Setup screen in the WT Local Management Tool (Slave in P-P mode, Administrator),
specify the settings in the following procedure:
Step 1: Select the ”Slave” setup tab.
Step 2: Specify the settings under Setup for Setup Parameters.
- System ID Number: Set the system ID number.
- Serial number at opposite WT: Set the serial number at the opposite WT.
- Encryption Parameter: Set the encryption parameter.
- Trans. Level: Set the transmission level.
- Interface Class: Set the interface class to AUTO or 10BASE.
- Radio Frequency: Set the radio frequency.
Step 3: Set the Network configuration for Setup Parameters.
- AP IP Address: Set the AP IP address.
- Subnet mask: Set the subnet mask.
- Default gateway: Set the default gateway.
- ARP Request: Set the ARP request to ON or OFF.
Step 4: Click the Setup button.
Figure 7-3 Configure the WT(slave)
Step1
Step4
Step3
Step2