Use and Care Manual

24
t
Automatic Buttonhole
*The size of buttonhole is automatically set by placing
the button in the automatic buttonhole foot (R).
*The button holder of the foot takes a button size up
to
2.5 cm (1˝) in diameter.
*Make a test buttonhole on a sample duplicating the
fabric, interfacing and seams of the actual garment.
*Place the button on the fabric sample and mark the
top and bottom to determine the position of
buttonhole.
*Use the interfacing on the stretch fabrics.
Turn the handwheel toward you to raise the needle
to its highest position.
Raise the presser foot lifter.
Set the pattern indicator at “BH” by turning the pat-
tern selector dial.
Attach the automatic buttonhole foot (R).
Pull the button holder to the back, and place the
button in it.
Push back the button holder toward you as far as
it will go.
q
w
e
q w e
r
r
t
Pull the buttonhole lever downward as far as it will
go.