Use and Care Manual

OPERATION AND SAFETY MANUAL
Trace Small Conduit or Pipes
• Locate Fiber Optic Cables In Plastic Pipe Without Tracer Wire
• Fiber To The Home Applications - Locate Fiber Optic Micro-Duct
• Plumbing Applications - Fiberglass Will Not Rust
• Trace Sewer Laterals (Up To 4” In Diameter) To Avoid Cross Bores
• Includes Accessory Kit
Duct Hunter
Rod
Diameter
Length
Recommended
Conduit Size
15-316-100 3/16” 100’ 1/2” - 1-1/2”
15-316-150 3/16” 150’ 1/2” - 1-1/2”
15-316-200 3/16” 200’ 1/2” - 1-1/2”
15-316-250 3/16” 250’ 1/2” - 1-1/2”
15-316-300 3/16” 300’ 1/2” - 1-1/2”
15-18-100 1/8” 100’ 1/2” - 1”
15-18-150 1/8” 150’ 1/2” - 1”
15-18-200 1/8” 200’ 1/2” - 1”
Jacket Core Wire
• Wear safety glasses and gloves.
• Keep rod inside reel when not in use. Out-of-control rod can harm personnel or property.
• Keep rod clean. Some contaminants (including water) can conduct electricity.
• Keep secure footing. Protect yourself from falling should pulling eye move suddenly or separate from rod.
• Check for rod damage prior to use. Cracks, gouges, nicks, or white stress marks on jacket or sharp bends will weaken rod.
Injury could result if rod breaks while pulling.
• Do not use slip joint pliers, locking pliers or powered pulling equipment on rod.
• Do not force a pull that is stuck. Check for kinks or obstructions.
• Avoid pulling rod over sharp edges.
• Do not bend rod beyond 6” radius.
Do not use on live circuits. Electric shock may result. The Duct Hunter is equipped with a metal tip and
continuous internal copper wire. Do not use on or near live circuits. Electric shock may occur.
WARNING - ADHESIVE
Read manufacturer’s instructions before using adhesive. In case of eye contact, ush with water and seek medical atten-
tion If skin contact occurs, apply solvent (such as nail polish remover) to area and gently remove adhesive. Wash solvent
off with water. Solvents should not be used in case of contact with eyes or open wounds.
Always wear safety goggles (ANSI Std. Z87.1) and gloves when working with adhesive and/or unprotected berglass rod.
See adhesive product label for Safety Data Sheet (SDS).
Warranty
Jameson products carry a warranty against any defect in material and workmanship for a period of one year from date
of shipment unless failure is due to misuse or improper application. Jameson shall in no event be responsible or liable for
modications, alterations, misapplications or repairs made to its products by purchaser or others. This warranty is limited
to repair or replacement of the product and does not include reimbursement for shipping or other expenses incurred.
Jameson disclaims any other express or implied warranty.
Mini
Duct Hunter™