User Guide

26
SECTION 5: SERVICE PROCEDURES
RINSE REGULATING THERMOSTAT REPLACEMENT
12. Once both wires are attached, ensure that there is no
excess hanging out where it could become pinched by any
cover or such.
13. Replace the heater nuts (if removed) and torque down as
required per the technical manual. Different models may have
different torque specifications. Contact Jackson Technical
Service if there are any questions regarding this.
AFTER MAINTENANCE ACTIONS
Once the new thermostat is installed, it will be nece-
sary to ensure that it operates at the required and appropriate
ranges. The new thermostat has an adjustment that can be
turned using a small flathead screwdriver. Several cycles will
need to be run on the unit while observing the final rinse tem-
perature. The thermostat needs to cycle so that the final rinse
water meets the indicated minimums on the machine data
plate for every cycle.
SPECIAL NOTES
Work performed on Jackson dishmachines by unau-
thorized or unqualified personnel may void the warranty.
Before beginning this or any other maintenance evolution on
a unit under warranty, you should contact a certified Jackson
technician or Jackson Technical Service. You can find a list of
qualified service agencies in the back of you unit’s installation
manual.
SPECIAL PARTS
Thermostat Replacement Kit: 06401-003-13-94*
*The kit contains a thermostat, imperial brass fitting,
jumper wires and instructions.
CONTACT INFORMATION
Jackson MSC Inc. provides technical support for all
of the dishmachines detailed in this manual. We strongly rec-
ommend that you refer to this manual before making a call to
our technical support staff. Please have this manual with you
when you call so that our staff can refer you, if necessary, to
the proper page. Technical support is available from 8:00 a.m.
to 5:00 p.m. (EST), Monday through Friday. Technical support
is not available on holidays. Contact technical support toll free
at 1-888-800-5672. Please remember that technical support is
available for service personnel only.
200 Series Technical Manual
7610-100-45-00 Rev. E (02/10/2006)
Calibrating the new thermostat.