Owner's Manual
5
english
JABRA EASYGO FOR PC
Please note: The lifetime of the battery will be signicantly reduced
if your device is left uncharged for a long period. We therefore
recommend that you recharge your device at least once a month.
TURNING YOUR HEADSET ON AND OFF
- Slide the on/off button towards the symbol “I” to turn the
headset ON. When you do so both indicators will ash on the
Jabra StatusDisplay™.
- Slide the on/o button towards the symbol “O” to turn the
headset o.
PRE PAIRED
Your headset is already pre paired to the USB Adapter out of the
box. If pairing is deleted and later pairing is needed this is done in
a few easy steps.
1. Put the USB Adapter into pairing mode by pressing the button
on the USB Adapter until the LED light is solid blue.
2. Put Your headset into pairing mode by pressing the MFB until
the light in the headset is solid blue and wait a few moments.
3. When the blue light on both headset and USB adapter is blinking,
pairing is complete and the headset and USB adapter will connect
automatically and the LED on the USB Adapter turns solid green
and the green LED on the headset is blinking.
PAIRING IT WITH YOUR PHONE
Headsets are connected to phones using a procedure called
‘pairing’. By following a few simple steps, a phone can be paired
with a headset in a matter of minutes.
1 Put the headset in pairing mode
- When you turn on your Jabra EASYGO for the rst time, the
headset will automatically start up in pairing mode – i.e. it is
discoverable for your phone. When the headset is in pairing
mode the Bluetooth® status indication on the StatusDisplay™ is
ashing.