User Manual

IS123-17B

J&D Manufacturing • 6200 Hwy 12 • Eau Claire, WI 54701 • 1-800-998-2398 • www.jdmfg.com

Page 2/4

Minimum 5’

Unrestricted Space

Required

DO NOT MOUNT

AGAINST WALL

It is important to select a proper location when mounting your circulation

fan. You must provide a minimum of 5’ unrestricted air flow on the back

side of the fan. Failure to provide the space needed for airflow may reduce

motor life and void the warranty.

If mounting bracket to structure, verify anchor points are strong enough for

added weight of bracket and fan. Attach top of bracket to structure with

(4) washers and (4) screws or bolts with nylock nuts (not provided) suitable

for your structure. DO NOT attach bracket to or against wall as this will

not give motor enough unrestricted air flow. (For pipe mount instructions

see Page 4 Step 2b.)

Prep motor for use by removing the 2 drain plugs located on the bottom

(flag mount) side of the motor. Removal of these plugs allows for drainage

of any moisture that might get inside the motor. DO NOT remove the plugs

on the top (capacitor) side of motor. Removal of these plugs will void

warranty and allow dirt and moisture into the motor, reducing the life of

the motor.

Attach fan to bracket by inserting bracket flag in between the motor flags.

Secure by using the center holes on the motor flags with (1) 3/8” x 1-1/4

hex bolt, (2) 3/8” washers and (1) 3/8” nylock nut as shown in Step 4a.

Using the crescent openings on the motor flags, install the (1) 1/4” x 1- hex

bolt, (2) 1/4” washers and (1) 1/4” nylock nut as shown in Step 4b. Adjust

the fan to the desired angle and tighten hardware to secure fan angle as

shown in Step 4c.