BATHROOM CABINETRY INSTALLATION GUIDE International customization Illustrations may not reflect every exact model
INSTALLATION INSTRUCTIONS Prior to installation Congratulations on choosing our product to be part of your living style. These quality, service and design ensure the elegant life of bathroom space. It is important that the product is unpacked and inspected for any damage, defects and that the product supplied is correct. If any of the above is apparent, DO NOT PROCEED WITH THIS INSTALLATION, AND IMMEDIATELY CONTACT THE STORE OF PURCHASE.
WALL HUNG VANITY WITH WALL BRACKET SYSTEM FOR HOLLOW WALLS Pre-cladding Place the final mounting screws into the "L" shape bracket. Use anchor if drill position is not on stud. All mounting screws must be tighten on stud. wall stud in wall horizontal noggin (*See below) To avoid damage remove cabinet drawers. Then cover the drawer runners with plastic sheet to prevent debris from getting into the mechanism. Refer to page 12-14 for removing your drawers/doors for Blum/DTC runners.
FREESTANDING VANITY (WITH ADJUSTING SCREWS) Use spirit level, mark & install all brackets level Place vanity onto wall in the desired hight. Check level from side to side and front to back. Packers may be required to level vanity unit and prevent cabinet from twisting once vanity is level fasten to wall using screws, cap and boss provided. Installers must check and adjust to avoid mistakes.
WALL HUNG STORAGE UNIT MIRROR CABINETS Carefully remove mirror doors from cabinet Locate stud in wall, using measuring tape mark stud centre on wall Use spirit level, mark & install all brackets level Finished Surface Place mirror box and level at desired height. Mark out stud centres on mirror box backing board. Use prepacked screws, insert brass threaded boss and continue to screw into wall until all screws firmly holding mirror box on wall.Screw on chrome screw caps to brass box.
BLUM DRAWER/HINGE ADJUSTMENT AND REMOVAL Unihopper DRAWER/HINGE ADJUSTMENT AND REMOVAL Blum Drawer Adjustment and removal instruction Unihopper general drawer/hinge adjustment and removal Side Adjustment Installation ① ④ ③Slide in ②Insertion Side Adjustment Height Adjustment Adjustment Removal Drawer insertion & removal ① Down Insertion Removal Up ② Unihopper Quick Assembly Drawer Slide Blum Hinge Adjustment and removal instruction Installation IMPORTANT Modul ① 1.
DTC DRAWER/HINGE ADJUSTMENT AND REMOVAL DTC Hinge Adjustment and removal instruction Side Adjustment CARE INSTRUCTIONS to allow your products to remain as elegant as the day they were installed please read the guide below. Depth Adjustment DOOR AND CABINET CARE: Regular cleaning with a damp cloth is sufficient. Never use strong detergents or abrasive cleaners as this may damage the surface finish of your furniture.
