User's Manual
Table Of Contents
- Contents
- Before You Begin
- About the 100T-HON Honeywell Telemetry Module
- Mounting the 100T-HON Telemetry Module
- Connecting and Configuring the Module and Instrument
- Installation Overview
- Programming the Mercury Instrument Parameters
- Honeywell Instrument Call-In Configuration
- Connecting the 100T-HON Telemetry Module to the Instrument
- Programming the 100T-HON Telemetry Module
Mounting the 100T-HON Telemetry Module
TDC
-1346-000 100T-HON Honeywell Telemetry Module Installation Guide 14
Proprietary and Confidential
2. Firmly push both tamper seals all the way into place with a 1/4-inch nut driver or similar blunt tool.
Note A tamper seal is fully seated when the top of the tamper seal is approximately 1/16-inch below the
top of the screw recess.
3. To reduce the risk of cable damage, secure the excess module cable with the cable ties from the module
installation kit. Pull the cable tight. Remove and properly dispose the excess cable tie.
4. Alternatively, the cable may be wrapped around the adapter plate as shown.
100T-HON telemetry module installation on a vertical flat surface or wall is complete.