User's Manual

APPENDIX D:

Electromagnetic emissions

The instrument has been tested and been found to comply with the limits for

electromedical devices imposed by EN 60601-1-2 standard. These limits

guarantee a reasonable level of protection against harmful interference in a

typical medical installation.

The instrument generates, utilizes and radiates energy at radio frequency,

and if not correctly installed and used as indicated in the instructions, can

cause harmful interference to other devices located in the immediate

vicinity. At all events, there can be no guarantee that interference will not

occur in certain situations.

The Trumpet must not be used in close proximity to other equipment

or stacked together with other equipment. If this cannot be avoided,

check the operation of the instrument carefully to ensure that it is

able to deliver normal levels of performance in the configuration

adopted.

Should the instrument appear to interfere with other devices — this can be

verified by switching off the instrument and then switching on again — it

may be possible to remedy the problem by adopting one or more of the

following solutions:

- change the orientation and/or the position of the device affected by

interference;

- distance the devices one from another;

- consult the manufacturer or a service centre for assistance.

Cables, transducers and accessories

Inventis declares compliance with EN 60601-1-2 standard using the

following cables, transducers and accessories:

1) Power cord (maximum length: 1.8 m)

2) Medical grade power adapter, model n° MPU31-106-P01K002-B1F4-

15V (L5)

3) REM probe (made by Inventis for the Trumpet)

4) TDH39 or DD-45 supra-aural headphones, 2 m shielded cable, dual

signal (same as supplied with the device)