User Guide

Installation, Assembly and Operating Instructions
FRONT ANTI-TIPPERS
MODEL NOS. 2226 AND 1326
DESCRIPTION QUANTITY
Lug Bolt 4
Locknut (fine thread) 4
Machine Screw 2
Locknut (coarse thread) 2
Anti-Tipper Triangular Assembly 2
Washer 4
Anti-Tipper Arm w/Bracket Clamps 2
INSTALLING FRONT ANTI-TIPPERS
(FIGURE 1)
NOTE: Refer to the INSTALLATION WARNINGS in
the SAFETY SUMMARY of this instruction sheet.
1. Remove the locknuts and the lug bolts from the anti-
tipper bracket clamps.
2. Position the anti-tipper bracket clamp over the wheel-
chair frame behind the front caster as shown in FIG-
URE 1.
NOTE: Position the anti-tipper arm on the outside of
the wheelchair as shown in FIGURE 1.
3. Squeeze bracket clamps together and insert the bolts.
4. Install the locknuts onto the lug bolts. Tighten securely.
5. Repeat STEPS 1-4 on the opposite side of the
wheelchair for the remaining anti-tipper.
6. Measure from the floor to the bottom of the wheels of
the triangular assembly.
7. Perform one (1) of the following:
TRIANGULAR ASSEMBLY 3/4-INCH FROM
FLOOR - Repeat STEPS 1-2 for the opposite tri-
angular assembly.
TRIANGULAR ASSEMBLY
NOT 3/4-INCH
FROM FLOOR - Adjust the height of the triangular
assemblies. Refer to ADJUSTING FRONT ANTI-TIP-
PERS in this instruction sheet.
The Front Anti-Tippers Kit (Right and Left)
consists of:
MODEL NO. 2226 1326
Size 1-inch 7/8-inch
PART NOS.
Right 1017846 1042413
Left 1017847 1042414
Pair 1035967 1042412
OVER
NOTE: Check ALL parts for shipping damage. In case of
shipping damage, DO NOT use. Contact Carrier/Dealer
for further instruction.
SAFETY SUMMARY
The following recommendations are made for safe in-
stallation and adjustment of the Front Anti-tippers:
GENERAL WARNINGS
DO NOT install or use this kit without first reading
and understanding this instruction sheet. If you
are unable to understand the Warnings, Cautions
or Instructions, contact a healthcare professional,
dealer or technical personnel before attempt-
ing to install this kit - otherwise, injury or damage
may occur.
INSTALLATION WARNINGS
After ANY adjustments, repair or service and BE-
FORE use, make sure all attaching hardware is
tightened securely - otherwise injury or damage
may occur.
Front anti-tippers are recommended by Invac-
are when using elevating legrests. Even though
a wheelchair is equipped with front anti-tippers,
individuals should be taught to elevate legrests,
swing front riggings aside and/or flip up footplates
so they are out of the way BEFORE placing feet
firmly on the floor when entering or exiting the
wheelchair. This will permit individuals to stand
close to front edge of the seat and lower him-
self/herself well enough back onto the seat.
Ensure Front Anti-Tippers are adjusted to the
same height - otherwise the wheelchair may
tip to one side and injury or damage may
occur.
INSTALLATION CAUTION
When securing the front anti-tippers to the wheel-
chair frame. DO NOT overtighten the attaching
hardware, otherwise damage to the wheelchair
frame may occur.