ASSEMBLY INSTRUCTIONS Description Item No.
BEFORE ASSEMBLY Thank you for purchasing this quality product. This product has been designed for easy assembly and constructed for durability. All parts were checked prior to packaging to insure quality. Prior to beginning assembly, however, make sure all parts and hardware are included and free of obvious defect. If a part is missing or defective, please contact the store where purchased. If hardware is missing, or you need help with assembly, please call toll free 888-944-8396.
PART LIST When unpacking, please be careful not to discard any parts with the packaging.
HARDWARE LIST When unpacking, please be careful not to discard any parts with the packaging. Before continuing, please make sure you have all of the following hardware: NO Description Qty 1 Bolt (M6 x 30mm) 2 Sketch NO Description Qty 14 7 Wooden knob (30 x 30mm) 12 Spring washer (6.5 x 11mm) 14 8 Medium screw (M4 x 30mm) 12 3 Flat washer (6.
STEP 1 Attach the top (A) and bottom panel (B) to vertical panel (C) with bolts (1), and washers (2) and (3) as shown below. Tighten with Allen key (4). STEP 2 Attach the top (A) and bottom panel (B) to side panel (D) with bolts (1), and washers (2) and (3) as shown below. Tighten with Allen key (4). Slide back panels (F) and back rail (E) into the grooves as shown below.
STEP 3 Attach the top (A) and bottom panel (B) to the other side panel (D) with bolts (1), and washers (2) and (3) as shown below. Tighten with Allen key (4). Attach support leg (G) to vertical panel (C) with bolts (1), and washers (2) and (3) as shown below. Tighten with Allen key (4). STEP 4 Attach back rail (E) to the unit with screws (5) as shown below .Tighten with a screwdriver.
STEP 5 Attach drawer sides (H) to drawer front (I) with screws (5) as shown below. Tighten with a screwdriver. Insert drawer bottom (K) into the grooves at bottom of drawer sides (H) and drawer front (I) as shown below. STEP 6 Attach drawer back (J) to drawer sides (H) with screws (5) as shown below. Tighten with a screwdriver.
STEP 7 Attach support bars (M) to bottom of drawers with screws (8) as shown below. Tighten with a screwdriver. STEP 8 Attach knobs (7) to front of drawers with screws (6) as shown below. Tighten with a screwdriver. Stick the warning labels (10) inside the drawers before use.
STEP 9 Attach the steel bands (9) to the unit with short screws (11) and attach the steel bands to the wall with screws (5) as shown below (to secure the product and prevent tipping). Tighten with a screwdriver.