Installation Guide
Table Of Contents
- Introduction
- Installation
- Installation environment
- Package contents
- Cable requirements
- Camera description
- Setting up the camera
- Accessing the SD card
- Mounting the IP fixed lens bullet camera
- Mounting the IP VF lens bullet camera and the IP motorized lens bullet camera (without the supplied back box)
- Mounting the IP VF lens dome camera and IP motorized lens dome camera
- Mounting the IP fixed lens dome camera
- Mounting the IP wedge dome camera
- Mounting the IP turret camera
- Using the camera with a recorder
- Using the camera with TruVision Navigator
- Specifications
- Pin definitions
Copyright
© 2017 United Technologies Corporation.
Interlogix is part of UTC Climate, Controls & Security, a
unit of United Technologies Corporation. All rights
reserved.
Trademarks and
patents
Trade names used in this document may be trademarks or
registered trademarks of the manufacturers or vendors of
the respective products.
Manufacturer
Interlogix
2955 Red Hill Avenue, Costa Mesa, CA 92626-5923, USA
Authorized EU manufacturing representative:
UTC Fire & Security B.V.
Kelvinstraat 7, 6003 DH Weert, The Netherlands
Certification
FCC compliance
Class A: This equipment has been tested and found to
comply with the limits for a Class A digital device, pursuant
to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference
when the equipment is operated in a commercial
environment. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and
used in accordance with the instruction manual, may cause
harmful interference to radio communications. Operation of
this equipment in a residential area is likely to cause
harmful interference in which case the user will be required
to correct the interference at his own expense.
FCC conditions
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference.
(2) This Device must accept any interference received,
including interference that may cause undesired operation.
ACMA compliance
Notice! This is a Class A product. In a domestic
environment this product may cause radio interference in
which case the user may be required to take adequate
measures.
Canada
This Class A digital apparatus complies with CAN ICES-
003 (A)/NMB-3 (A).
Cet appareil numérique de la classe A est conforme à la
norme CAN ICES-003 (A)/NMB-3 (A).