User Manual
Table Of Contents
- Package Contents
- Hardware Description
- Installing the Switch
- Installation Steps
- DIN-Rail Mounting
- Wall Mount Plate Mounting
- Wiring the Power Inputs
- Wiring the Fault Alarm Contact
- Wiring the Digital Inputs / Outputs (GE-DSH-73)
- Installing the SFP transceiver
- Factory Redundant Ring Application
- Transportation Networking and Public Wireless Service
- X-Ring Application
- Coupling Ring Application
- Dual Homing Application
- Connecting to the Console Port
- Login in the Console Interface
- CLI Management
- About Web-based Management
- Requirements
- Logging on the Switch
- System
- Port Management
- Protocol
- Security
- Digital Input/Output (GE-DSH-73)
- Power Over Ethernet (GE-DSH-82-PoE)
- Factory Default
- Save Configuration
- System Reboot
- System Commands Set
- Port Commands Set
- Trunk Commands Set
- VLAN Commands Set
- Spanning Tree Commands Set
- QOS Commands Set
- IGMP Commands Set
- MAC / Filter Table Commands Set
- SNMP Commands Set
- Port Mirroring Commands Set
- 802.1x Commands Set
- TFTP Commands Set
- SystemLog, SMTP and Event Commands Set
- SNTP Commands Set
- X-ring Commands Set
- PoE Command Set
- Address Table
- What is PoE?
- Switch's RJ-45 Pin Assignments
- 10/100Mbps, 10/100Base-TX
Chapter 5: Web-Based Management
98 GE-DSH-73/DSH-82 and DSH-82-PoE User Manual
Figure 5-42: RSTP Port Configuration interface
This page includes the following fields:
Object Description
Path Cost:
The cost of the path to the other bridge from this transmitting bridge
at the specified port. Enter a number 1 through 200,000,000.
Priority:
Decide which port should be blocked by setting its priority as the
lowest. Enter a number between 0 and 240. The value of priority must
be the multiple of 16.
Admin P2P:
The rapid state transitions possible within RSTP are dependent upon
whether the port concerned can only be connected to exactly
another bridge (i.e. it is served by a point-to-point LAN segment), or
can be connected to two or more bridges (i.e. it is served by a shared
medium LAN segment). This function allows the P2P status of the link
to be manipulated administratively. True means the port is regarded
as a point-to-point link. False means the port is regarded as a shared
link. Auto means the link type is determined by the auto-negotiation
between the two peers.
Admin Edge:
The port directly connected to end stations won’t create bridging loop
in the network. To configure the port as an edge port, set the port to
“True” status.
Admin Non STP:
The port includes the STP mathematic calculation. True is not
including STP mathematic calculation. False is including the STP
mathematic calculation.