Assembly Instructions

ASSEMBLY GUIDE
15
7. Troubleshooting
If the mains power supply is lost or becomes disconnected from the control unit during movement of the drives, zero
setting might be necessary.
Error code Note How to handle it
E17
Ξ Motor 1 wrong direction of operation Switch the motor line or hall line
E18
Ξ Motor 1 overload Reduce load
E21
Ξ Motor 2 not connect Check the cable
E22
Ξ Motor 2 error in current sampling channel Replace the control panel
E23
Ξ Motor 2 missing phase; phase line disconnect Check if the motor is not properly connected to the line
E24
Ξ Motor 2 hall error, or hall line disconnect Check the hall signal, or replace the cable
E25
Ξ Motor 2 internal short circuit Replacing the motor
E26
Ξ Motor 2 locked-rotor Re-initialize
E27
Ξ Motor 2 wrong direction of operation Switch the motor line or hall line
E28
Ξ Motor 2 overload Reduce load
E31
Ξ Motor 3 not connect Check the cable
E32
Ξ Motor 3 error in current sampling channel Replace the control panel
E33
Ξ Motor 3 missing phase, phase line disconnect Check if the motor is not properly connected to the line
E34
Ξ Motor 3 hall error, or hall line disconnect Check the hall signal, or replace the cable
E35
Ξ Motor 3 internal short circuit Replacing the motor
E36
Ξ Motor 3 locked-rotor Re-initialize
E37
Ξ Motor 3 wrong direction of operation Switch the motor line or hall line
E38
Ξ Motor 3 overload Reduce load
E40
Ξ Controller drop line in series Check the cable
E41
Ξ Error in the series signal Check the cable, or replace the controller
E42
Ξ Memory error Replacing the controller
E43
Ξ Disable sensor error Replacing the controller