Installation Instructions

ManualsBrandsIntercrown ManualsBlinds & ShadesCordless Panel Track Window Shade Light Filtering 78W" x 84L" Linen

99-9043-000

Panel Track

Instructions for Installation, Operation & Cleaning

Congratulations on your Intercrown

™

Panel Track

purchase! You can take pride and comfort in knowing

that your new shade will be easy to install, will add

to your home’s beauty, and will perform to your

expectations. Before beginning installation, please

take a moment to review the following instructions

and safety warnings.

IMPORTANT SAFETY INFORMATION

Read all instructions, warning tags, and labels provided with your

product to avoid injury. Keep this manual. Please contact our

Customer Service Center at the phone number, email or address

below for additional support. For additional safety tips visit the

Home Safety Council at www.homesafety.org.

Tools Needed

3/32” drill bit (drill into wood)

7/32” drill bit (drill into

drywall for anchor)

Items in the Box

Headrail with Panel Glides and Wand 1

Mounting Brackets

Fabric Panels

Bracket Screws

Drywall Anchors

Spacers (Inside/Ceiling Mount only)

Allen Wrench

Intercrown Enterprise, LTD.

713 Post Rd. ∙ Madison, WI 53713

877-687-2796 ∙ info@intercrownusa.com

Time Required:

30 Minutes

AFFORDABLE INNOVATION

Summary of content (4 pages)

PAGE 1
Panel Track AFFORDABLE INNOVATION Instructions for Installation, Operation & Cleaning Congratulations on your Intercrown™ Panel Track purchase! You can take pride and comfort in knowing that your new shade will be easy to install, will add to your home’s beauty, and will perform to your expectations. Before beginning installation, please take a moment to review the following instructions and safety warnings.
PAGE 2
BEFORE INSTALLATION 7 CLEANING AND CARE Panel gliders can shift during shipment, so before installing your Panel Track shade, please inspect the headrail to ensure the panel gliders are properly situated. To clean shade panels: Dust or vacuum gently. To remove wrinkles: Steam or iron shade panels on a low heat setting. 1. If panel gliders have slid off of headrail, make sure they are put back onto the headrail in order as shown below. Panel gliders are labeled 1-6.
PAGE 3
6 OPTIONAL: SHORTEN PANELS 1. Mark 1” below desired length on hanging panel. 1 2. Remove panel from glide. 2 3. Lay panel out fully on flat surface. Remove bottomrail using allen wrench. 3 4. Cut marked panel with shears. 4 3 INSIDE/CEILING MOUNT (For outside mount, skip to page 4). 1. Remove clips from mounting brackets. 1 2 2. Measure 3 inches in from each side of the window and mark clip locations. Space additional clips evenly.
PAGE 4
6. Pull wand along headrail, fully extending panel glides. Starting at the right side, attach one shade panel to the velcro on each glide. 5. Screw brackets into place with screwdriver. 6 5 6 6. Hook headrail on front of brackets as shown. Press headrail back until secure. OUTSIDE MOUNT (For inside/ceiling mount, refer back to page 3). 1. Center headrail over window, with the top of the headrail sitting a minimum of 85 inches from floor or sill. Mark at each end and ensure level.