User manual

Below are descriptions of the options:

Enable Port Check this box to enable port mapping;

Forwarding (1): uncheck this box to disable port mapping.

Private IP (2): Input the IP address of the computer on the

local network that provides Internet service.

Computer Name (3): Pull down the menu and all the computers

connected to the router will be listed here. You

can select the computer name without checking

the IP address of the computer.

Type (4): Select the type of connection: “TCP” or “UDP.”

If you’re not sure, select “Both.”

Port Range (5): Input the starting port number in the left field

and input the ending port number in the right

field. If you only want to redirect a single port

number, just enter the port number in the left

field.

Comment (6): Input any text to describe this mapping, up to 16

alphanumerical characters.

Add (7): Add the mapping to the port forwarding table.

Reset (8): Remove all entered values.

Port Forwarding All existing port forwarding mappings will

Table (9): be displayed here.

Delete (10): Select a port forwarding mapping by clicking the

“Select” box of the mapping, then click “Delete

Selected” to remove the mapping. If there’s no

existing mapping, this button will be grayed out.

Delete All (11): Delete all mappings in the virtual server table.