Service Guide

Hardware Installations and Upgrades
Intel® Server System SC5650HCBRP Service Guide 49
2. Remove a drive carrier from the hot swap drive cage. Press in on the green latch (see letter “A” in the
following figure) at the end of the drive carrier to disengage the drive carrier from the drive cage. Pull out on
the black lever (see letter “B”) to push the drive carrier partially out of the drive cage. Slide the drive carrier
all the way out of the drive cage.
Figure 48. Releasing Drive Carrier from Hot Swap Drive Cage
3. Remove the four screws that attach the plastic retention device to the drive carrier. Two screws are located
on each side of the retention device.
/
NOTE
Store the plastic retention device for future use.
Figure 49. Removing Retention Device from Drive Carrier
4. Remove the hard drive from its wrapper and place it on an anti-static surface.
5. Set any jumpers and/or switches on the drive according to the drive manufacturer's instructions.
6. With the drive circuit-side down, position the connector end of the drive so that it is facing the rear of the
drive carrier.
7. Align the holes in the drive to the holes in the drive carrier and attach the drive to the carrier with the screws
that were formerly attached to the plastic retention device.