Owner's Manual

Page 11 of 18 2477S - Rev: 1/21/2014 7:27 AM
Remove SwitchLinc as a Controller
If you no longer want SwitchLinc to control another device (or are removing SwitchLinc from your
INSTEON network), it is important that you remove the responder link from SwitchLinc. Configure using
home automation software (such as HouseLinc) or follow the steps below for each responder.
1) Press and hold SwitchLinc Set button until beep.
LED will start blinking green.
2) Press and hold SwitchLinc Set button until beep.
LED will start blinking red.
3) Press and hold responder Set button until double-beep (or LED blinks).
SwitchLinc will double-beep and its LED will stop blinking.
4) Test by tapping SwitchLinc on and off.
Responder will not respond.
Make SwitchLinc a Controller of Multiple Responders
Configure using home automation software (such as HouseLinc) or follow the steps below to make
SwitchLinc a controller of multiple responders.
1) Press and hold SwitchLinc Set button until it beeps.
SwitchLinc LED will start blinking green.
2) Tap SwitchLinc Set button.
SwitchLinc LED will double-blink green.
3) For each responder you are adding:
a. Tap on/off or press and hold to adjust responder to desired state.
b. Press and hold responder Set button until it beeps (or LED flashes).
SwitchLinc will double-beep.
4) After all responders have been added, tap SwitchLinc Set button.
SwitchLinc LED will stop blinking.
5) Test by tapping SwitchLinc on and off a couple of times.
All the responders added will respond.
Remove SwitchLinc as a Controller of Multiple Responders
Configure using home automation software (such as HouseLinc) or follow the steps below to unlink
multiple responders from SwitchLinc.
1) Press and hold SwitchLinc Set button until it beeps.
SwitchLinc LED will start blinking green.
2) Press and hold SwitchLinc Set button again until it beeps again.
SwitchLinc LED will start blinking red.
3) Tap SwitchLinc Set button.
SwitchLinc LED will double-blink red.
4) For each responder you are removing, press and hold responder Set button until unit beeps and/or
LED flashes.
5) Tap SwitchLinc Set button.
SwitchLinc LED will stop blinking.
6) Test by tapping controller button a couple of times
All responders removed will not respond.