Owner Manual

ManualsBrandsInSinkErator ManualsKitchen ApplianceInvolve H-View Instant Hot Water Dispenser System in Satin Nickel

The wall outlet for your dispenser must have power supplied to it continuously

and must be fused. It should not be controlled by the same wall switch

that operates your disposer, unless using an InSinkErator SinkTop Switch

™

*component parts pre-installed on dispenser

PREPARATION

START HERE

Identify locations for the dispenser

faucet, tank and filter (if applicable).

Check to make sure there is proper

clearance (see chart at left) for

dispenser handles to be fully opened.

Check to make sure counter is not

too thick (see chart at left).

Make sure there is a grounded

electrical outlet under the sink.

Turn off water supply.

If using the sink sprayer hose hole,

remove nut that connects sprayer

hose at bottom of faucet.

Using adjustable wrench, remove

nut connecting sprayer washer

flange in sprayer hole.

Plug hose opening with either a 1/8"

plug or a 1/4" cap (not supplied).

If you have to drill through sink or

countertop, you may need to rent or

purchase the appropriate tools.

Consult a professional before drilling into

a surface other than stainless steel.

Required minimum

from center of hole

to wall

Maximum counter

thickness (depth)

What if you don’t have a sprayer hole

or don’t want to use it?

Many homeowners replace the

soap dispenser in their sink with an

instant hot water dispenser.

If drilling a hole into a stainless steel

sink or counter top, you can cut

a mounting hole for the dispenser

with a hole saw for stainless steel,

or you can use a hole punch.

Required Hole Size

1-1⁄4" – 1-1⁄2"

Dependent on model

HC-View-SS ..... 2-5⁄8" .................... 3"

H-View-SS ....... 2-5⁄8" .................... 3"

HC-Wave-SS .... 2-5⁄8" .................... 3"

H-Wave-SS ...... 2-3⁄8" .................... 3"

H-Contour-SS ... 2" ...........................3"

H-Classic-SS .... 2" ........................... 3"

COMPONENTS IN THIS PACKAGE

H-Classic-SS

Semi-Circular

Mounting Plate

Flat Gasket

Wing Nut

Trim Ring

3/4" Screws (2)

HC-View-SS

H-View-SS

H-Wave-SS

HC-Wave-SS

Small Steel* FiberRubber* Large Steel

Washers

1-1/2"

1-1/4" 1-1/4"

1-5/16"

3/8" Tube

Brass Nut / Ferrule /

Tube Insert

Quick Connector

3/4" Screws (2)

Extension & Star Nut*

Small Steel* FiberRubber* Large Steel

Washers

1-1/2"

1-1/4"

Semi-Circular

Mounting Plate

Flat GasketWing Nut

3/4" Screws (2)

1-1/4"

1-5/16"

3/4" Screws (2)

Extension & Star Nut*

H-Contour-SS

Tank

To see a tutorial of this installation:

http://goo.gl/AZOHu